Bulb Replacement for Peterson # 440 Tail Light

Question

Question:

in the peterson #440 tail light, there are two different bulbs, one function and one marker. What is the part# of the marker bulb?

asked by: LARRY Y

0

Expert Reply:

The Peterson Combination Trailer Tail Light # 432200 uses either 1156 ( # DI49VR ) or 1157 ( # DI79VR ) replacement bulbs. The 1156 are single filament bulbs (marker lights) and the 1157 are double filament bulbs (multi-function).

expert reply by: Erik B

0

Answer 1

There are a wide variety of trailer lights offered and these come with different type of construction. Some lights may not be user-serviceable (such as some LED types and sealed waterproof lights) but usually trailer lights that use standard…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

Hey Christian, welcome to the world of RV-ing! So in addition to the Roadmaster Nighthawk #RM-676 you're also goin to need: - A baseplate kit, like the Roadmaster Direct-Connect Base Plate Kit #RM-521453-5. These attach to the Jeep itself so you…

view full answer...

Answer 7

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 8

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 9

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 10

Hey Bernie! Yes, the Black Bracket and Single Wire Plug for Thin Line Series Trailer Clearance and Side Marker Lights #A65PB fits both the #MCL63AB and #MCL63RB. This bracket is required for surface mounting. If you need anything else feel free to…

view full answer...

Answer 11

Hello Kurt, I can definitely help you out with the right clearance and side markers for your 6 x 12 dump trailer. I attached an image to reference for the lights/reflectors, these are the DOT requirements: - Rear reflector (#4 on diagram) 2 of the…

view full answer...

Bulb Replacement for Peterson # 440 Tail Light

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching