1156 Incandescent Light Bulb - Single Contact Bayonet - 26.9 Watt - Soft White - Qty 2

See what our Experts say about this Diamond Vehicle Lights

• What Bulb Type Does The Gustafson 12V RV Porch Light # 277-000484 Use
  The Gustafson 12V RV Porch Light # 277-000484 can take an incandescent 1141 # DI67VR, 1156 # DI49VR, or 1295 bulb type.
  view full answer...
• Wiring a Powered Modulite Power Wire and Backup Lights on a 2007 Mazda 5 Towing a Trailer
  If the dealer hooked up the trailer wiring harness on your vehicle then they must know of a circuit that provides enough amperage to power trailer lighting and not affect the vehicle wiring in any way, if there is an over draw or short. We recommend that the power wire from the item # C59496, be connected to the vehicle battery positive post to eliminate any chance of damaging the sensitive circuitry on the vehicle. If you need to install a 5-Way adapter, item # 47515, to provide reverse...
  view full answer...
• Replacement Bulb for Rv Scare light item # RVSL21
  The # RVSL21 Scare light uses an 1156 replacement bulb that is widely available. We carry this bulb also, part # DI49VR. These bulbs have two posts that slide into slots in the socket and then you turn the bulb approximately 1/4 to 1/2 turn to lock it into the socket. There should be 2 wires going to the bulb socket. One will attach to the bulb base for ground and the other will attach to the center of the base at the bottom for power to the bulb.
  view full answer...
• What is the Power Draw of the Optronics RV Ceiling/Wall Light # RVSL21
  The Optronics RV Ceiling/Wall Light, # RVSL21, will draw 1.4 amps at 12-volts. The light bulb in the Optronics light is a standard 1156 automotive bulb, like # DI49VR. This bulb has a Watt rating of 26.9W.
  view full answer...
• Troubleshooting - - Error Code on Curt Triflex Brake Controller and Bench Testing
  The double dash (- -) on the Curt TriFlex Trailer Brake Controller # C24VV indicates that there is a power or ground wire issue. The first thing to check will be the wiring connectors both to the brake controller and the vehicle. Be sure that there is not any corrosion or damage to any of the connectors. Next you will want to check the fuse in the engine compartment on your 2014 Chevrolet Silverado 1500. According to the owners manual it is in the # 1 slot. If you find that all the...
  view full answer...
  
• What Bulb Does the Bargman 30-84-022 Taillight Use
  The Bargman 30-84-022 Taillights likely use an 1156 type bulb part # DI49VR which is the most common for trailer taillights. This bulb uses a baronet style connection. The bulb type number will be etched into the base of the old bulb for reference.
  view full answer...
• Does Bargman Tail Light w/ Backup # 30-92-002 Come With Sockets and Bulbs and Instructions
  The inside of the Bargman Surface Mount Tail Light w/ Backup, part # 30-92-002 has two sockets with two bulbs. The top bulb is a # DI49VR single filament bulb that is for the reverse light. The bottom bulb is a # DI79VR double filament bulb that is for the tail light functions. I went out to the warehouse and took the lens off of the unit and took a picture that will show you what the inside looks like. I have attached the picture for you to see. The Bargman light does not come with any...
  view full answer...
  
• What Type of Bulb is Used in the Optronics Dual-Face Post Mount Light ST52AA
  I pulled the Optronics Dual-Face Post Mount Trailer Light, # ST52AA, and it uses a 1156 bulb. For a replacement bulb, you can use part # DI49VR.
  view full answer...
• Does the Trailer Dome Light with Stainless Steel Base Run On a 12 Volt System
  Yes, you can run 2 or 3 of dome light # IL91CB off of a 12 volt battery. This light was designed to work on a 12 volt system so you will be good to go. This light uses an 1156 bulb, # DI49VR, which is readily available.
  view full answer...
• Troubleshooting Timed Brake Controller Wiring And Bench Test Procedure
  You could have a bad connection on your Draw-Tite Activator Trailer Brake Controller 5100. Since this is a timed brake controller the power going to the brakes will vary based on how long the brake pedal is pushed. The red wire is the signal that comes from the brake pedal switch to tell the controller when to brake. You will need to check that all the other wires have a good connection and not damaged. The black wire is your main power wire. Depending on your vehicle this will either...
  view full answer...
• Which Replacement Bulb for Gustafson 277-000484 RV Porch Light
  The Gustafson # 277-000484 RV Scare light can use a few different bulbs. It'll take a 1141, 1295 or an 1156 bulb. I'd recommend using an 1156 bulb like # DI49VR.
  view full answer...
• What is Power Draw for Optronics Trailer Dome Light Using Incandescent and LED Light Bulbs
  An 1156 incandescent bulb, like # DI49VR that is in the Optronics Trailer Dome Light # IL91CB draws approximately .94 amps. If using an LED bulb in this light, like part # ARC28FR, the draw is 0.65 amps.
  view full answer...
• Options for Amber Trailer Exterior Lights
  The LED Porch Light # DG52526PB that you referenced uses multiple LEDs (27, in fact) that are not replaceable with an amber LED element. The lights that you purchased, parts # RVILL33 and # RVILL34, also do not have replaceable elements. The LED "bulbs" are made for replacing many popular standard incandescent bulbs; this one replaces an 1156 bulb type like # DI49VR which is fairly common in RV aplications. You could install a new light made for an incandescent bulb and then just replace...
  view full answer...
• How Large Of a Mounting Hole Is Needed For the Backup Light w/ Chrome Housing # BU11CS?
  To install the Backup Light w/ Chrome Housing # BU11CS you will need a 3/4" hole for the light socket and wire to pass through. As the light also uses the mounting hardware for its ground circuit you will need to ensure that your mounting surface is grounded, otherwise you will need to also run a jumper wire from the mount to a ground connection. The light includes an 1156 Incandescent Bulb # DI49VR. You can swap this out for a longer lasting and more efficient LED Bulb # DI25VR.
  view full answer...
• Bulb Replacement for Peterson # 440 Tail Light
  The Peterson Combination Trailer Tail Light # 432200 uses either 1156 ( # DI49VR ) or 1157 ( # DI79VR ) replacement bulbs. The 1156 are single filament bulbs (marker lights) and the 1157 are double filament bulbs (multi-function).
  view full answer...
• Tack Room Door Lock For A 2016 CM Dakota Horse Trailer
  What type of latch do you have on your tack room door? If it is a cam door style lock like the Lock Side-Door Bar Lock Assembly part # 305736 then you can use something like the Global Link Vise Lock for Cam-Action Door Latch part # 295-000025. If this is not the type of latch you have on your tack room then please send me a photo and I would be happy to let you know if we have any options. I see the hinge in the picture you included. So if it is the hinge you are looking to replace, I...
  view full answer...
  
• Can 1156 Light Replace 1141 Bulb
  Yes a 1156 bulb can fit into the same socket as a 1141. It will be much brighter. For a 1156 that is incandescent we have the part # DI49VR for a pair.
  view full answer...
• Troubleshooting Tekonsha Voyager Not Engaging Trailer Brakes and Light Staying Green
  It sounds like your Tekonsha Voyager Trailer Brake Controller # 39510 is faulty. While the controller is proportional and will not send power to the trailer brakes when parked by using the manual slide knob it should send power to the brakes even when not moving. Since you have the green light on the controller it senses there is a trailer connected. You can choose to bench test the controller by connecting the black wire to 12 volt power, white wire to ground and using a 12 volt 1156 Incandescent...
  view full answer...
• Troubleshooting Curt Venturer Trailer Brake Controller With Brakes Always Locked On
  The Curt Venturer Trailer Brake Controller # C74VV could be faulty. To find out for sure you can bench test the controller as per the instructions. I have included those below for you to reference. Before removing it for a bench test I suggest checking the red wire that runs to the brake switch. This should only show 12v power when the brake pedal is pressed. If the brake switch is faulty this would cause the brake controller to believe it needs to send power to the blue brake wire. To...
  view full answer...
• Replacement Light Lens and LED Elements for Optronics Dual-Face Trailer Light ST52AA
  Yes, we do sell a replacement amber lens for the Optronics Dual-Face Post-Mount Trailer Light # ST52AA that you referenced. The replacement lens part number is # A52AB. We also offer a replacement type 1156 incandescent bulb, part # DI49VR.
  view full answer...
• Availability of 1156 Incandescent Bulb for Scare Light
  We have an incandescent 1156 bulb set part # DI49VR that you could use.
  view full answer...
• Which Light Bulbs Fit The Tail Lights On a 2005 Fleetwood Pop Up Camper?
  Without knowing exactly what tail light is on your 2005 Fleetwood Pop Up I cannot say exactly what bulbs your camper uses. There is no way to look up the exact factory parts but the most commonly used bulbs in were the 1156 # DI49VR, 1157 # DI79VR and 194 # A194B. You should be able to find the bulb number on the bulb base otherwise if you can verify which tail light assemblies you have I can help you find the correct bulbs.
  view full answer...

Do you have a question about this Vehicle Light?