Troubleshooting Camper Slide-Out That Needs to be Pushed In
Question:
I have an 18:1, 9000 rpm slide room motor on my big slide out on my trailer. I am having to help the slide room in by pushing it. Is there such a thing as having it geared differently so it moves in slower and with more torque?
asked by: Jim B
Expert Reply:
It's technically possible to move to a higher gear ratio for your slide-out but it would require you to completely gut out the existing set up (not just the motor) and it's also likely that it wouldn't resolve the issue you are having.
If you're having to help move the slide-out room in by pushing it then there is something going on besides a low gear ratio. A common cause for this type of issue is the slide-out catching on something as it's trying to move in. This could simply be carpeting inside the camper or a stick that might have found its way in or around the rails. I recommend inspecting these areas to see if anything needs to be moved or cleared away.
The issue could also be caused by a weak battery. Check to make sure your battery is fully charged and in good condition.
If this does not resolve the problem please let me know and we can continue to troubleshoot.
Product Page this Question was Asked From
Lippert Venture RV Slide-Out Actuator - 40" Stroke Length
- RV Slide Out Parts
- Motor Parts
- Actuator
- Lippert Through-Frame Slide-Out Systems
- Lippert
more information >
Continue Researching
- Shop: Lippert Venture RV Slide-Out Actuator - 40" Stroke Length
- Video: Let’s Check Out the Lippert Venture RV Slide-Out Actuator
- Q&A: How To Wire An Advent Air AC System To A Two-Wire Furnace
- Video: Review of Advent Air Air Distribution Box With Thermostat - ACRG15
- Shop: Grease Seal - Double Lip - 2.250" ID - 3.376" OD - GS-2250DL
- Shop: Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners - White
- Article: Most Popular Wheel Bearings
- Shop: Trailer Hitch
- Search Results: 25580
- Video: etrailer VS Dexter Self Adjusting Brakes Comparison
- Q&A: What is the Best Grease for Trailer Bearings
- Search Results: trailer leaf springs
- Video: Timken Bearing Kit Installation - Enclosed Trailer
- Shop: Trailer Wiring
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Article: Trailer Wiring Diagrams
- Q&A: Does etrailer Carry Replacement Slide Out Parts for a 2020 Grand Design Solitude 5th Wheel
- Search Results: trailer jack
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Wiring Diagram for Advent Air Conditioner ACM135
- Video: Grease Seals 10-36 (pair) Feature Review
- Shop: Grease Seals 10-36 (pair)
- Search Results: rv slide out parts
- Video: Finding the Right Trailer Wiring Harness
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Shop: Gooseneck Hitch
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles
- Shop: Brake Controller
- Search Results: trailer brakes
on RV Slide Out Parts
