Troubleshooting Melted Wires On Breakaway Switch
Question:
I just purchased a 2017 Blue Ridge fifth wheel and when backing into a spot the emergency break away pin was pulled and I continued to back a short distance before I realized what had happened. When I went to replace the pin it would not go back in and the insulation was melted off of the wires on the emergency switch. I have had this happen on my other fifth wheels and simply replaced the pin and continued on down the road. I can replace the break away switch but I must have some other problem. Any suggestions? Thanks.
asked by: Johnny R
Helpful Expert Reply:
Typically, any melted wires are an indication of a short in the wiring. You will need to check the wiring of your breakaway system, and look specifically at the wiring that connects to the battery. Look for any signs of damage or pinched or cut wires and fix as needed.
You may find that the wiring between the battery and the switch shorted out on the frame of your trailer causing the problem.

Product Page this Question was Asked From
Hopkins Engager Trailer Breakaway Kit w/ Charger, LED Tester, and 5 Ah Battery - Side Load
- Trailer Breakaway Kit
- Kit with Charger
- Side Load
- Single-axle
- Tandem-axle
- LED Tester
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Switch for Curt Soft Trac I and II Trailer Breakaway Kits
- Shop: Vehicle Tow Bar Wiring
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Testing Trailer Brake Magnets for Proper Function
- Shop: Brake Controller
- Q&A: Breakaway System Kept Trailer Brakes On and Melted Wiring
- Q&A: How to Wire Electric Brakes on a Tandem Axle Trailer
- Q&A: Troubleshooting Melted Trailer Breakaway Wiring
- Shop: Trailer Wiring
- Q&A: Trailer Ground Wire Gets Hot and Smokes when Connected to Dodge Truck
- Q&A: Does the Trailer Wiring Need to be Waterproof on a Boat Trailer to Avoid a Short or Damage
- Q&A: Preferred Method of Grounding Trailer Lighting Circuits
- Shop: Optronics LED Trailer Clearance or Side Marker Light - Submersible - 3 Diodes - Rectangle - Red Lens
- Shop: Liquid Electrical Tape
- Shop: Universal Magnetic Tow Lights w/ Wireless Transmitter and 4-Way Flat Trailer Connector - Red LEDs
- Shop: Optronics LED Clearance or Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber Lens
- Q&A: Does It Matter Which Wire From a Trailer Breakaway System Switch Gets Used
- Article: Trailer Wiring Diagrams
- Video: A Closer Look at the Hook Probe Circuit Tester
- Video: What to Know About the Hopkins Engager Push-To-Test Trailer Breakaway Kit w/ Built-In Charger
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Hopkins Engager Trailer Breakaway Kit w/ Charger, LED Tester, and 5 Ah Battery - Side Load
- Shop: Optronics LED Trailer Clearance or Side Marker Light w/ Reflex Reflector - 6 Diodes - Red Lens
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer brake controller
- Search Results: trailer brake switch
- Video: Checking Out the Fastway Zip Trailer Breakaway Switch with Coiled Cable
- Video: How to Choose a Trailer Brake Controller
- Search Results: trailer wiring