What is Preferred Method For Securing Truck Tool Box to Truck Bed if J-Hooks Don't Work

Question

Question:

I have a UWS box on my Tacoma that has come loose from the original J Bolt mounts. The box is able to slide forward and back, along with side to side. What is the best way to secure the box to the bed again?

asked by: Grant

0

Expert Reply:

Best way is to drill a hole through the floor of the tool box and then through the bed of the truck and then run a bolt through both. This is the best way to secure a tool box.

expert reply by: Jameson C

0

Answer 1

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 2

In order to determine which replacement key you will need for your UWS Truck Toolbox, you will need to get the code off of the lock core. I have attached a picture for you showing the location. The code should start with CH and followed by 3 numbers.…

view full answer...

Answer 3

Dan, they won’t. The Dexter 7K ABS brakes #DX69WR / #DX79WR are specifically designed for Dexter Tow Assist axles - the flange offset and ABS tone ring position are unique to Dexter’s design. On Lippert 7K axles, the sensor alignment won’t match, so…

view full answer...

Answer 4

Since your 2021 Subaru Outback Wagon does not have factory trailer wiring you'd need to first install a 4-way with part #118467 and then convert it to a 7-way with a 7-way adapter like the part #37185 to give you the 7-way. But since you are…

view full answer...

Answer 5

There is a lock set specifically for the adjustable ball mount #63072. It includes a lock for the adjustable part and a locking hitch pin and they are keyed alike. The set is #63069.

view full answer...

Answer 6

I've looked through our spare tire locks, and have seen that we don't offer one that uses a J-bolt. Fulton offers an inexpensive carrier/Lock solution, part #FETCSTL0701 that would allow you to attach and lock a spare tire onto your trailer…

view full answer...

Answer 7

The difference between the standard and underslung B&W Continuum Weight Distribution System is the coupler style they are designed for. If you have a standard coupler like the #CA-5400-B mounted to the top of your frame then you need the standard…

view full answer...

Answer 8

We have spare tire lock #FSTL0603 that you could use. It works with wheel studs up to 9/16 inches. I have included a link to a video review of this lock for you.

view full answer...

What is Preferred Method For Securing Truck Tool Box to Truck Bed if J-Hooks Don't Work

Product Page this Question was Asked From

Continue Researching