Can Fuse Taps Be Used When Installing A Brake Controller
Published 08/25/2015 >
Question:
When in stalling my brake controller on my 2010 town and county . Can I use fues taps , and is it safe to do so?
asked by: Terry B
Expert Reply:
If you are looking for a power source for your brake controller, I do not recommend using a fuse tap. The brake controller's power needs to be ran through an appropriately sized circuit breaker and to the battery post. The installation instructions will tell you what size circuit breaker to use, usually a 30-amp breaker is sufficient for brake controllers.
If you are looking for a way to connect to a stoplight wire, you could use a fuse tap for that. The stoplight wire would only draw a signal, not amperage. You would want to be careful when choosing the fuse to tap into for the stoplight wire. Something like the upper brake light on the rear hatch, a light that only lights up when the brake is depressed, would be an option.

Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Brake Controller
- Video: A Closer Look at the Redarc Encapsulated Power Diode for Tow-Pro Brake Controllers
- Shop: Curt Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Roadmaster Single Park Light Diode
- Shop: Redarc Encapsulated Power Diode for Tow-Pro Brake Controllers
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Shop: Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Shop: Suspension Enhancement
- Search Results: sumosprings
- Search Results: brake controller
- Search Results: timbren ses
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: How To Prevent a 2007 Jeep Grand Cherokee From Sagging While Towing
- Q&A: Suspension Enhancement for 2009 Jeep Grand Cherokee
- Q&A: Can Fuse Tap be Used to Acquire Brake Signal for Brake Controller Install of 2017 Toyota Highlander
- Q&A: How to Test Brake Controller without Trailer Connected
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - Up to 2 Axles - Proportional
- Q&A: Brake Controller Wiring on 2010 Jeep Grand Cherokee
- Q&A: How Does Redarc Encapsulated Power Diode RED34FR Get Wired To 3rd Brake Light?
- Q&A: Where Would Diode Need to Install on Brake Controller If it Was Needed
- Shop: Trailer Wiring
- Search Results: 12 gauge wire
- Video: Comprehensive Review: Universal Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers
- Video: In-Depth Review of the Universal Installation Kit for Trailer Brake Controller
- Search Results: 20 amp inline circuit breaker
- Video: How to Choose a Trailer Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Hitch