Replacement Parts for Bulldog Square Jack
Updated 07/28/2015 | Published 07/27/2015
Products Featured in This Question
Question:
Bulldog 12 Jack on 30 foot goose neck trailer, Landing gear has slid out and no longer retract? Assumed it was held in by spring, and was looking for replacement and Diagram showing how it attaches?
asked by: Matt W
Expert Reply:
The replacement parts we have for the Bulldog Square Jack # BD182500 are a Replacement Gear Kit # BD500212 and a Replacement Screw and Nut Kit # BD500217. These are the two most likely aspects of the jack to be causing your problem.
I have attached the only two diagrams we have related to this trailer jack. The inner tube is held to the outer tube by the screw and nut assembly.
Product Page this Question was Asked From
Bulldog Square Jack - Fixed Leg - Sidewind - 12-1/2" Lift - 10,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Side-Mount Jacks
- Steel
- 9001 - 10000 lbs
- Manual Jack
- 12-1/2 Inch Lift
- Weld-On
- 1 Jack
- Bulldog
more information >
Continue Researching
- Shop: Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity
- Search Results: trailer jack
- Q&A: How to Remove Pin in Handle Shaft to Replace Gears on an Older Bulldog Model 12 Square Jack
- Video: A Closer Look at the Bulldog Square Jack
- Shop: Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
- Shop: Replacement Gears for Bulldog Sidewind Trailer Jacks with 5,000-lb Capacity
- Video: Comprehensive Review: Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
- Search Results: bulldog trailer jack
- Shop: Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Shop: Bulldog Square Jack - Side Pin Drop Leg - Spring Return - 10K Lift - 26" Travel
- Q&A: What is the Purpose of the Spring Inside of a Bulldog 12K Square Jack
- Q&A: Trying to Get Inner Drop Leg of Bulldog Jack to Move After Getting Stuck All the Way Down
- Q&A: Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Q&A: Troubleshooting A Roll Pin That Won't Slip Into Place In A Bulldog 10K Square Jack
- Shop: Replacement Sidewind Gear Kit for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Shop: Gooseneck Hitch
- Search Results: bd500212
- Q&A: What is the Inner Diameter of Replacement Thrust Bearing for 12K Bulldog Square Trailer Jacks
- Shop: Bulldog Square Jack - Drop Leg w/ Non-Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Search Results: bd500217
- Search Results: 500217
- Q&A: Troubleshooting Bulldog Electric Landing Gear that Turns But Does Not Raise or Lower Jack
- Search Results: 12k jack
- Search Results: jack thrust bearing
- Shop: RV Plug Adapters
- Video: Comprehensive Review: Mighty Cord RV Power Cord Adapter
- Video: Checking Out the 22x60 Flint Hill Goods Cargo Carrier for 2" Hitches
- Video: All About the Mighty Cord SurgeMinder Surge Protector and Circuit Tester
- Shop: Trailer Hitch
- Video: Ultimate Overview of the Replacement Gears for Curt Heavy Duty Direct Weld Square Jack