Replacement Key for etrailer.com Trailer Hitch Receiver Lock

Question

Question:

I previously purchased a hitch pin lock from you and I have lost one of the keys. On the key that I do still have it says CCP on one side of the key and LB029 on the other. Is there any way to purchase any more of these keys? Thanks.

asked by: MIGUEL L

0

Expert Reply:

Thank you for your purchase of our etrailer.com Trailer Hitch Receiver Lock # e98881.

We do offer a replacement key set for this lock, It is the "Replacement Key for etrailer Hitch and Coupler Locks - Key 029 # e75UR.

expert reply by: Jon G

0

William P.

6/19/2020

can you get me a replacement key for hitch pin lock? The one key I have says CCP LBO 44

Reply

Chris R.

6/23/2020

Yep - you can get replacement keys with part # e64HR, which is coded to match your 044 lock.

Reply

Answer 1

Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…

view full answer...

Answer 2

The Reese Tow and Store Lock Kit part #RP7014700 does not have a keyed alike option so there would be no way to obtain multiple kits with the same key unfortunately. However, you could combine any of the etrailer.com locks and they would all come…

view full answer...

Answer 3

Correct, the etrailer.com Trailer Coupler Locks like part #e98895 or part #e98889 must all be purchased at the same time in order to take advantage of the keyed alike option. I wish we could match the lock to a set of keys you already have but this…

view full answer...

Answer 4

I took some measurements off the etrailer Trailer Coupler Lock #e98895 that will help you to determine if this will fit your coupler. The maximum width of the coupler tongue channel is 4-1/2" wide, and 2-3/4" deep. The locking pin is…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey James, you can go with a 4k axle leaf spring like the part #e22YR in place of what you have now while it has a slightly higher weight capacity it's not enough that it would create a harsh ride quality. This is a 26 inch long spring though so…

view full answer...

Answer 7

Hello Mark, Happy to help you find the right weight distribution hitch to meet your needs. I don’t have a database that supplies specs for trailers (though it would be pretty sweet if one existed), so based on my research, the Rockwood Mini Lite…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement Key for etrailer.com Trailer Hitch Receiver Lock

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching