Can LED and Incandescent Lights be Mixed, Used at the Same Time on a Trailer
Question:
Your expert stated since marker lights are all on the same circuit they shouldnt be mixed as the incandescent bulbs would cause the LED bulbs to draw too much current. The way I see it each light is a parallel circuit even if each one is fed off of the same hot wire to a common ground and shouldnt effect each other. Am I overlooking something?
asked by: Al H
Expert Reply:
The lights don't have voltage or amperage regulators so it could potentially be an issue. However, I am in the minority around here about whether or not it would be a problem. Most others are certain that it would not be a problem so majority rules.
I still believe that the potential for a problem is there if you mix LED and incandescent lights but it seems to work out for most people. But I would be remiss in my duties if I didn't at least mention the potential for a problem.
Product Page this Question was Asked From
Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Red
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 2-1/2L x 1-3/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: Westlake ST205/75R15 Trailer Tire with Glossy Black Eagle Aluminum Wheel - 5 on 4-1/2
- Video: Detailed Breakdown of the Adapter 7 Pole to 4 Pole with Tester and Cover
- Search Results: load range e trailer tires and wheels
- Search Results: 2057515 load range e
- Shop: Americana Trailer Wheel Center Cap - Stainless Steel - 3.19" Pilot
- Shop: Americana Trailer Wheel Lug Nut - Chrome Plated - 1/2"-20
- Search Results: wheel for trailer jack
- Search Results: electric trailer jacks
- Search Results: trailer jack accessories and parts
- Search Results: ram trailer jack
- Shop: Tandem Axle Teardrop Trailer Fenders for Enclosed Trailers - 14" to 15" Wheels - Qty 2
- Shop: Removable Wheel for Trailer Valet JXS Trailer Jacks
- Shop: Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Shop: Ram Removable, 6" Poly Caster Assembly for 2" Jack Tube - 1,200 lbs
- Video: Checking Out the Ram Removable, 6" Poly Caster Assembly for 2" Jack Tube
- Q&A: Troubleshooting Trailer Running Light Circuit that Gets Hot
- Q&A: Should LED Trailer Lights be Mixed with Incandescent Trailer Lights
- Video: Review of CE Smith Trailer Safety Chains - Safety Chains - CES42QR
- Video: Comprehensive Review: Optronics LED Clearance or Side Marker Light
- Video: In-Depth Review of the Trailer License Plate Bracket
- Video: Detailed Breakdown of the Thinline LED Clearance and Side Marker Light
- Video: Yates Endcap for Boat Trailer Rollers: The Breakdown
- Search Results: trailer safety chains
- Q&A: Troubleshooting LED Lights Not Working On Trailer
- Article: Trailer Wiring Diagrams
- Q&A: 4 Pin Wiring Harness for 2025 Chevrolet Equinox
- Article: Trailer Lighting Requirements
- Q&A: Parts Needed to Add Electric Brakes to ShoreLand'r Boat Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
on Trailer Lights
