Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Going by the colors that you mentioned, it sounds like you have the typical set-up, green wire for right turn and brake, white wire for ground, yellow wire for left turn and brake, brown with green wire for right side running lights, and brown with…
view full answer...To determine the correct wiring for your trailer you will need to use a circuit tester, item #PTW2993, and attach the wires from the connector by function only. The light wires should be as follows, red is the stop turn wire and the black is the…
view full answer...Sounds like you might be looking for a T-handle style flush door latch lock like part #L4080 which comes with a key.
view full answer...In order to find the correct replacement bearings for your Harbor Freight trailer you are going to need to identify what you currently have. I recommend pulling the hubs and inspecting the bearings. They may have the part number stamped in the side,…
view full answer...Your 4-pin/5-wire wiring harness is what is called a "wishbone" type which simply means that there are two separate running light wires, one brown and one pink. This allows a separate running light wire for each side of the trailer which…
view full answer...Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…
view full answer...We do not carry a radial trailer tire in 5.30-12 size but there is another option. You can also use a 145/80-12. Both tires will fit on a 4 inch wide rim and can have similar weight capacities. The one size difference is that the 145/80-12 is 0.6…
view full answer...The Ramp Door Hinge #PLR1902 does require welding of both portions. The tab gets welded as you stated to one side and the outside cylinders get welded to the opposite side. I've attached a couple pictures to assist.
view full answer...Thanks For the photos of your hinges. That helps a lot when we are trying to find something for a customer. I have attached a photo of a hinge, part #PLR1902 that may work for you. You can check out the photo and see the dimensions for the hinge. The…
view full answer...Some 5-Pole flat connectors use a total of 6 wires. They operate as follows: Blue - trailer brakes Green - right hand brake and turn signals Yellow - left hand brake and turn signals Brown/Green - right hand running lights Brown/Yellow - left hand…
view full answer...The On/Off Push Button Switch for RV Lighting #DG52452VP doesn't have a specific wiring diagram. Basically it can install on any circuit and will allow the circuit to pass voltage through when on and would kill it when it is off.
view full answer...Most likely it's possible but the level of modification you'll need to do is hard to say. We have ramp door hinge kits like the part #PLR1904-Z which you'd weld to the back of the trailer and then attach a ramp door to. But most likely…
view full answer...Filter Your Search