Wesbar Adapter - 7-Way RV to 4-Way or 5-Way Flat - 18" Long

See what our Experts say about this Wesbar Trailer Wiring

• Recommended Trailer Wiring For A 2016 Volvo XC60
  The Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C56355 you referenced is a compatible fit for your 2016 Volvo XC60. This custom-fit T-connector plugs into your vehicle's wiring harness, which is located in your rear cargo area. You will have to remove the trunk floor coverings and the rear scuff panel to access this harness. Once you've plugged in the T-connector, run the hot lead up to your car battery. Connect the lead to the included fuse holder, and...
  view full answer...
• Wesbar Adapter 7-Way To 4 or 5-Way Flat Adapter Compatibility With 2017 Chevy Silverado
  Yes, the Wesbar Adapter - 7-Way RV to 4-Way or 5-Way Flat - 18" Long # 707250 is compatible with your 2017 Chevy Silverado Z-71 with trailer package. This adapter will fit into the factory 7-way connector to allow you to use a 4-way flat trailer connection or a 5-way trailer connection.
  view full answer...
• Recommended 7-way to 4-way Flat Trailer Connector Adapter
  Yes, we have a few options for a 7 way to 4 way flat trailer connection. One option if you don't need an extension is the Hopkins Adapter 7 Pole to 4 Pole with Tester and Cover, # 47345. This adapter has an LED tester internally to allow you to check your vehicle side trailer wiring functions at the connection. If you need an extension adapter, I recommend the Wesbar Coiled Adapter - 7-Way RV to 4-Way or 5-Way flat # 787196 for an 8 foot option. For a much shorter extension adapter...
  view full answer...
• Recommended 7-Way Trailer Connector to 4-Way Vehicle Connector Adapter
  Yes, you can use the Wesbar Adapter item # 707250 to connect a 7-Way trailer connector to your Escapes 4-way connector. However, you won't be able to control the brakes or have an accessory line that keeps your battery charged. If you are concerned about these functions you will want to add the Universal Installation Kit item # ETBC7. The kit includes a pre-wired 7- and 4-way trailer connector that mounts easily at the rear of your Escape with an included bracket. This kit is designed...
  view full answer...
• How To Convert From A 7-Way To A 5-Pole Connector For Towing A Boat Trailer
  If your truck has a 7-way connector then you already have a pin for the reverse lights, but it might not currently be hooked up since a lot of people rarely use it and will typically just cap it off. The reverse light function on a typical 7-way is the center pin. You can take the boot off of your 7-way and get into the wiring to see if you have the wire ran or not. If not you'll connect a wire to the center terminal and splice it into the reverse light circuit in either one of your tail...
  view full answer...
  
• Recommended 4-Way to 7-Way Vehicle Wiring Adapter
  The Adapter 4-Pole to 7-Pole and 4-Pole part # 37185 is a great and easy way to convert the 4-way you have to the 7-way you want and still have a working 4-way if needed in the future. This is a simple plug and play installation if you are only looking for the lighting signals you will simply plug in the 4-way to the adapter and you're all set. Simply ground the connector to the vehicle frame or an existing ground.
  view full answer...
• Is 7-Way of Westbar Adapter # 707250 USCAR Standard Pin Out
  The USCAR pin out is the standard 7-way pin out which the Wesbar adapter part # 707250 matches.
  view full answer...
• Parts Needed To Convert Boat Trailer With Tandem 3,500LB Axles To Electric Over Hydraulic Disc Brake
  For your boat trailer with the tandem 3,500lb axles you will need two of the Kodiak Disc Brake Kits # K2HR35DS and two Bearing Kits # DBRKHW35EZ. These will replace the surge drum brake hubs you currently have with Dacromet and Stainless components for corrosion resistance in water. The HydraStar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes # HS481-8067 will supply you with the actuator, breakaway battery, breakaway switch, HBA-Cam(To work with factory brake controller)...
  view full answer...
• Does 2003 Mercedes ML320 Need Brake Controller to Activate Trailer Brakes
  Sounds like the brake lights circuit of your trailer wiring was either accidentally or intentionally ran to the brake output circuit of your trailer wiring which is why your brakes lock up when the brakes are touched. You do need a brake controller to take care of applying the brakes as full 12 volts from a light circuit will always lock them up. A brake controller will vary the voltage of the circuit to give the brakes the correct amount of pressure. The easiest solution is the Curt...
  view full answer...
• Adapter for Boat Trailer with 5-Pole Flat Trailer Connector
  Since your boat trailer has a 5-pole connector with 6 wires, you have what's known as a wishbone harness, with the running lamp circuit split into two wires, with one running down each side of the trailer. To make this work with the 7-way connector on your tow vehicle, you'll need an adapter like # 707250. In order for the reverse lockout on the trailer to function, you'll want to make sure that the center pin on your 7-way is tied into the reverse lamp on your truck. You can confirm...
  view full answer...
• Recommended 7-Way to 4-Way Wiring Adapter for 2015 VW Tiguan R-Line Package
  It sounds like you you have a standard 7-way trailer connector, so I recommend either the Pollak 7 Pole to 4 Way Connector Adapter # PK12716 or the Wesbar Adapter - 7-Way RV to 4-Way # 707250. If you happen to have a European 7-way, then you will want adapter # 118710.
  view full answer...
• Recommended Wiring or Adapter for 7-Way Connector to 4-Way Utility Trailer Plug
  A trailer can be wired to connect to a 7-way without using all the functions. I recommend the Epicord 7-Way Molded Trailer Plug with Junction Box - 10' Long # 277-000141 to give you a clean molded connector and then only connect the functions in the junction box needed for the trailer. Your other option is to use a basic adapter from 7-way to standard 4-way like # PK12716 or # 707250. When making electrical connections a little dielectric grease like # 11755 will help with the electrical...
  view full answer...
• Adapter Needed To Convert A 7-Way To 5-Way And Lockout Surge Brakes
  If you have a factory 7-way on your vehicles they should be wired to the reverse light circuit so all you would need is an adapter to go from your 7-way to a 5-way like part # 707250. Typically this wire is purple or yellow and is the center pin of the 7-way. You can put your tow vehicle in reverse and use a tester like # PTW2993 to see if the 7-way is indeed wired to the reverse light circuit or just use the adapter to test if it is. If it's not then you'll need to run a wire from the...
  view full answer...
• Available 4-Pole and 7-Way Trailer Wiring Extensions
  We do offer many types of trailer wiring extensions. For 4-pole flat trailer wiring you can use 4-foot extension # HM47115 or 1-foot part # 9653P. For 7-way trailer wiring we have 28-inch extension # TLW6028, 21-inch # TLW6021 or one of the others shown on the linked page.
  view full answer...
• How To Connect A 7 Way to 6 Way On A Camper
  If you already have a 6-way square connecter on your camper, the best thing for you to do is to remove the 6 way-square connector and replace it with a 7-way connector. The 6-way square plug is an unique plug. When you cut off the 6 way square plug and connect The Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End # PK12706. Then you would connect the wires to the new 7 way like below. Before cutting off the 6 way plug I would test the wires to see what goes where first....
  view full answer...
• Will 7-Pin to 5-Pin Trailer Wiring Adapter Power Reverse Lights
  Hello Keith, Yes, on an adapter like the Wesbar Adapter - 7-Way RV to 4-Way or 5-Way Flat # 707250 the lights will still be powered the same way, and that includes the reverse lights.
  view full answer...
• Trailer Connector Options for 2018 Nissan Pathfinder
  We do indeed have trailer connector harnesses that will work with your 2018 Pathfinder. If you needed a 4-pole trailer connector, use # 118670. For a 7-way trailer connector, use # 118273. Both harness kits include the relays needed to activate the trailer wiring tow package. If you use the 7-way and the trailer has electric brakes, you'll need a brake controller to actuate them. The Tekonsha Primus, part # TK90160 is a reasonably priced proportional controller that would provide reliable,...
  view full answer...
• Recommended 5-Way Adapter Harness
  In order to add a 5-way harness to your X5 you'll need to use the Curt Trailer Connector Adapter item # C57187 with a 4-way connector like the Curt Powered Tail Light Converter item # C59236 you were looking at. I am sorry but they don't make vehicle specific 5-way wiring harnesses which is why you need the adapter. If your vehicle has a 7-way connector you will want to use the Wesbar Adapter item # 707250.
  view full answer...
• Recommended Simplest Conversion for Trailer 4-Way Flat to 5-Way for Surge Brake Lockout & Jeep 7-Way
  For your 2015 Jeep Grand Cherokee, the 7-way trailer connector is already a huge help. I recommend simply using the 7-Way to 5-Way/4-Way Trailer Adapter # 707250 or the # 707250. This will give you the 5-way that includes the reverse function to allow you to add the solenoid lockout to your surge coupler. Using a Reverse Lockout Solenoid for Demco Hydraulic Brake Actuators - Non-Bypass # DM11993 or the Titan # T4748800 will allow you to backup without the braking pressure to your trailer...
  view full answer...
• Wiring Adapter for 4-Way Connector on 2014 Ram 1500 Snug Top Canopy
  What you need to pair the 4-Way on your Snug Top Canopy to the 7-Way connector on your 214 Ram 1500 is the Pollak 7 Pole to 4 Way Connector Adapter # PK12716, but if you need a lead to reach the canopy wiring then the Wesbar # 707250 might do the trick since it's the same thing but with an 18" wire lead. If this doesn't look like what you have on your canopy please reach out with some photos and I'll be more than happy to help you figure out what you're needing!
  view full answer...
• Will Wesbar 7-Way to 5-Way Adapter 707250 Fit 2013 Chevy Silverado
  Yes, the Wesbar 7-way to 4/5-way part # 707250 is exactly what you would need. This would plug right into your 7-way and give you a 4-way or 5-way flat connector for your trailer.
  view full answer...
• Recommendation For Using Trailer 4-Way With Vehicle 7-Way
  Since you have a 7-way wired into your 2016 Ford Transit, I recommend using a simple adapter to go from a trailer with a 4-way to your vehicle's 7-way. This will allow you to easily switch between the two by simply inserting or removing the adapter as needed. I recommend the Pollak 7 Pole to 4 Way Connector Adapter # PK12716 for just a plug, or if you want some length, the 18" long Wesbar Adapter - 7-Way RV to 4-Way or 5-Way Flat # 707250. I have added links to video reviews of these...
  view full answer...
• Creating 7-Way Trailer Connection Adaptor for 13-Way European Bike Rack Lighing
  We do not have any European 13 way adapters to make your bike rack lights compatible so you will need to rewire it. So you would need to create a custom adapter using a 7-way connector and probably a junction box to protect an external converter box that you will need to separate the stop light from the turn signal for your 13 way bike rack wiring. For this conversion, I recommend the Vehicle to Vehicle Tail Light Converter # 118158 along with the Wesbar Adapter - 7-Way RV to 4-Way or...
  view full answer...
• 7-Way to 4/5 Pole Wiring Harness Adapter for a 1996 Ford F-250
  It sounds like you're looking for the Wesbar Adapter # 707250. This wring adapter has a 4/5 pole on one end and a 7 way on the other so you can use your truck's factory 4/5 pole and connect to your trailer's 7 way. If you're looking for something different, feel free to reach back out and and I'd be happy to help.
  view full answer...

Do you have a question about this Trailer Wiring?