Custom Fit 2023 Porsche Cayenne Accessories

Hey Anthony! A lot of it depends on where you live, really. There are plenty of trailer setups that normally run without propane covers and are just fine, but if you're in an area where it's exceptionally cold and wet then that would be a…

The difference between the prices of the JR Products Automatic Changeover LP Gas Regulators and Camco Automatic Changeover 2-Stage Propane Regulators are in the BTU per hour, which as you correctly noted, is important information. The JR Products…

To verify which regulator would be the best choice for your 2022 Outdoors RV Mountain Series Blackstone 280KVS you will need to verify exactly how many BTU's all of your propane appliances and accessories will require. Unfortunately, Outdoors RV…

There are actually several options available to replace your Winntec 6020. A lot of propane regulators carry similar specs and are pretty comparable when it comes to quality. The Winntec 6020 regulator that you referenced is a low pressure regulator.…

There isn't a way to install zerk fittings on your spindle to make it an EZ lube spindle, but we do have Bearing Buddies which are designed for spindles like yours that do not have the zerk fittings to make installing grease in them easier. You…

While we don't have a go to kit we can build one using parts that are available. First is the HydraStar Vented Marine Electric Over Hydraulic Actuator #HS381-8067. If you are building from scratch we have the HydraStar Marine Electric Over…

Some trailers are equipped with EZ Lube spindles, which have a grease fitting or zerk in the end of the spindle, and a small hole in the spindle that lets grease enter the interior of the hub and reach the bearings. This allows grease to be added to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

In order to calculate where the axles would go on your trailer, there are several things that need to be taken into consideration. You will have to mock up the trailer with the suspension and axles to get the weights needed to determine where the…

The 60/40 rule is a great guideline for setting up axle placement on a trailer. But in reality the goal is to place the axles where the trailer will have 10-15 percent of the total trailer weight as tongue weight. The distance you would need to…