Videos
for Toyota Highlander Owners
Help Articles
for Toyota Highlander Owners
Expert Answers
for Toyota Highlander Owners
Hello Royer, Thanks for writing in, we’re glad you found us! The correct wiring harness for your 2020 Toyota Highlander XLE without the factory tow package is the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C76CR. Even…
view full answer...Hello Mike, Thanks for writing in. The Trailer Mate Trailer Hitch Receiver - Custom Fit - Class III - 2" #TMT67FR is going to be a great fit for your 2020 Toyota Highlander. The hitch itself weighs around 36 pounds. If you are looking to tow a…
view full answer...Hey Aaron, great question! The Trailer Mate Trailer Hitch Receiver #TMT67FR is definitely a budget friendly option for a hitch on your 2026 Highlander. This is basically the economy line from Curt. The welds are a little different (but will still do…
view full answer...Hey Marvin! Yes, your Trailer Mate Trailer Hitch #TMT67FR will be able to handle your jetski and trailer. The hitch has a max gross trailer weight of 5,000 lbs and tongue weight of 500 lbs. At 890 lbs you are well below the limitations of the hitch…
view full answer...The 2 easiest ways to tell if your 2020 Toyota Highlander XLE has the factory tow wiring is to either check behind the paneling next to the 3rd row seating on the driver's side to see if a connector is there that the Curt #C56RV module plugs…
view full answer...Hi Heidi, I did some searching and the smallest kit I could find is the Valterra StayPut Curved Leveler and Chock for Tandem Axles part #VAL48MB. The wheel chocks are 7" long x 5 3/4" wide x 5" tall and can give your trailer up to a 4…
view full answer...The most likely issue is a blown or missing fuse for the trailer lighting. Locate the fuse panel under the hood, on the driver's side, near the fender. Your Owner's Manual can additionally provide you a picture of the location and…
view full answer...Hi Nathan; as long as you have a hitch and ball mount the 7-way and brake controller will be everything you need to tow your camper. The Universal Installation Kit for Trailer Brake Controller #ETBC7 is going to be the most cost effective way to add…
view full answer...Hey Mathieu, since you have an Al Ko 3500 lb trailer axle with a 5 on 4-1/2 inch bolt pattern the correct replacement hub/drum would be the part #AKHD-545-35-K which happens to be pre-greased so it's ready to install.
view full answer...You may be able to replace the 10 x 1-1/2 inch electric brakes on your trailer with the more common sized 10 x 2-1/4 inch assemblies. The potential issue is the Dexter 2.8K axle that your existing electric brakes are mounted to. This particular axle…
view full answer...As far as wiring for the 2024 Toyota Grand Highlander, we do have the Curt #C59236 available which is more of a universal hardwire harness. Unfortunately there are not any plug-and-play options that have been confirmed to fit as of yet (October 4,…
view full answer...I'm really sorry to hear that your '14 Highlander got totaled and hope every one involved is ok! For your new 2020 Toyota Highlander Limited I recommend going with the Curt #C45CR as it's one of few hitches for your vehicle that's…
view full answer...

























