Hi Dan; what kind of bike rack do you have? Curt has this restriction on pretty much all of their Class III hitches. For a hitch that doesn't have this restriction I recommend the Draw-Tite Max-Frame Trailer Hitch #75703. This is a Class IV hitch…
To install all necessary wiring for a 7-pin connector and a brake controller on your 2011 Ford E-350 start with the Curt #C56020 4-pole wiring harness. For installation of this harness, if you don't already have them, you will want a Powerbuilt…
It looks like you have found the factory plug on your 2012 Ford E-350 that is used for installing a 4-Way Trailer Wiring Harness like the Hopkins #HM11140665. This port is found underneath the van at the rear, inside the driver's side frame rail.…
We can help you with a 4-pole flat trailer wiring harness for your 2012 Ford E-350 van. All types of wiring kits are shown on the linked page. These include products for vans equipped with no factory wiring, vans with a factory 4-pole set-up and vans…
In order to install a 7-way trailer connector and brake controller on a 2012 Ford F-150 you will first want to start with a 4-way trailer connector, the Replacement OEM Wiring Harness for Ford F-150 part #C56110 which is plug and play. Once we have…
On your 2012 Ford E350 Van with the factory towing package the brake controller port should be located behind the center of the dash above the stereo. You will need to remove the center panel above the stereo and to the left. Once it is removed there…
If your 2012 Ford Van has the proper connectors at the back where the harness you found terminates then you could use #118261 to add a 7-Way. Or you could use #HM40975 and hardwire it to the wires you found using #PK11998. For a brake controller if…
Hi Maxwell Trailers; since there are no base rail kits designed for that truck it will take some custom fabrication to install rails on there. You can use the Reese Universal Base Rails and Installation Kit #RP30035, or just the Reese Universal Base…
Hello Carla, We have the perfect fit for you, the Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center - Custom Fit - Class V - 2" #41945 is confirmed to fit your E-450 RV Cutaway. You will need to remove the back step in order to have a…
Hey Ginny, thanks for coming by! So with those weights it looks like you'd need a hitch with a tongue weight of 675 or higher. The only hitch we have that's close to that is the Curt Trailer Hitch Receiver #14053 which has a max tongue weight…
The connectors you have found are not confirmed to be for the trailer wiring and we don't have any wiring harness that is a fit for what you described. Because you don't have the factory trailer wiring, I recommend starting with the T-One…
The three radial special trailer (ST) tires we offer in size 215/75-14 can be seen on the linked page. These include the Taskmaster #TTWTRTM2157514D in Load range D, the Provider #TTWTR21514 in Load Range C and the Kenda Karrier #AM10229 also in Load…
