Custom Fit 2011 Nissan Xterra Accessories

The thinnest material is 1/16" to fit the LED Trailer Mini Clearance and Side Marker Light with Grommet #MCL10AKB. You can connect the wires with the 22-18 Gauge Butt Connectors #05730-5.

Both the LED Trailer Mini Clearance #MCL10AKB and Uni-Lite LED Clearance #MCL11RKB will require an 11/16" hole for mounting. These both use the same Grommet #A11GB.

If you think of the back of the trailer as flat and straight left to right, and the sides of the trailer flat and straight front to back, where they meet in the corner would be a right angle. If you were to mount the light in that corner, so that it…

Yes, for Dexstar wheel 17-384 it is a 5 on 5 bolt pattern. Not very common nowadays but we do have some options. Wheel #AM20428 is a spoke wheel with the 5 on 5 bolt pattern or the mini-mod version is #AM20446DX. We have other 15 inch wheels with the…

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

It is normal to have continuity between the brake(blue) wire and ground(white) wire. The electric trailer brake is an electromagnet when it has power it attracts to the steel inside the hub/drum. If you are having issues with your trailer brakes…

If you are only getting the 8 volts when you pull the pin using a meter like #PT89ZR, that has nothing to do with your brake controller as the breakaway battery is powering that from the trailer itself. You can confirm your brake controller is…

All the brake controller needs to sense a trailer connection so that you can test it is a slight amperage draw on the output circuit. For that you can use a circuit tester like the part #PTW2993 with one pin grounded and the other on the output pin.…

The Tekonsha Primus IQ #TK90160 will only send power to the 5 o'clock pin of your 7-way when it senses a connection on that pin. The trailer connected needs to read on the controller for the controller to send any power. When a trailer with…

I looked up your order and found out you have the Electric Trailer Brake Kit part #AKEBRK-35-SA and the correct replacement magnets for these are the Replacement Magnet Kit for 10" Electric Trailer Brake Assemblies part #AKBRKR-M10.

Since you already have a relay harness installed from the #118525, you will be able to install the 7-way harness #118267 in place of the 4-way harness from #C56225. If you plan on using a trailer with electric brakes, you will need a brake controller…

Assuming that when you tested the resistance of the brakes you were testing the two wires on each magnet and getting 2.0 and 2.8 ohms the magnets on your trailer are not working correctly and will need to be replaced. For 7" brakes you should…