Custom Fit 2009 Toyota Tacoma Accessories

Hey Nicholaos, thanks for reaching out! I can definitely help you out with some suspension enhancement for your 2015 Toyota Tacoma, but anything we have to offer will be far from what you're thinking will turn heads. Our kits are designed more…

If your 2009 Toyota Tacoma has the factory 7-Way connector at the rear of your vehicle the factory brake controller port is located underneath and left of the steering column, taped to another harness near the emergency brake pedal. There will be a…

Yes, the 23" x 51" UWS Cargo Carrier #UWS65XR is a one piece carrier. It uses a thickened aluminum shank which is welded to the carrier.

My first thought was "150 lbs seems like a pretty low tongue weight capacity". Based on what I can see online though, the 2022 Toyota RAV4 XLE Premium AWD does indeed have a towing capacity of 1,500 lbs and a tongue weight capacity of 150…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

Saris Traps Fork-Block #SATRK34-BLK3 is designed to hold bikes with 9mm axles but not through axle bikes but we do have several truck bed bike racks that will accept through axle bikes, see link. One of the more popular options is the Kuat Dirtbag…

The Tekonsha Prodigy P2 part #90885 is a really great option for your 2009 Toyota Tacoma. This is a proportional brake controller that senses how hard you apply the vehicle brakes and applies a relative amount of trailer braking pressure. Next, for a…

You will need to start with a 4-way (if you do not have one). For that you would want the #118496. From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want the Brake Controller…

Hey Jon, It sounds like your trailer is already set up with electric drum brakes and you're seeing the break-away switch/battery, which is a requirement depending on the weight of the trailer. The trailer should have a 7-way connector to plug…

There is a difference between a 7-way round and and 7-way rv blade connector. If you take a look at the accompanying photo, which is from our linked article on trailer wiring you can see that the connector on the left has blade-style pins while the…

We recommend that you pull the hubs off your trailer to inspect and repack the bearings every 12 months or 12,000 miles. If at this time the bearings still appear in good condition then there is no need to replace them. There isn't a general rule…

The short answer to both of your questions is yes. You can remove the backing plate or brake assembly and use the existing hub with integrated drum by itself, or, you can simply replace it with an idler hub. Based on the photos, I would suggest…