It looks like you have either the Curt Double Lock, Flip and Store Underbed Gooseneck Hitch part #C60720 or the Curt EZr Double Lock Underbed Gooseneck Trailer Hitch part #C60683 installed on your 2016 Ford F-250. If that is the case then I have…
To wire your electric brakes you will want to run 10 gauge wire #10-1-1 to one of the brakes and run it to the other brake, using butt connectors like #05732-2 to connect them. The grounds will not be spliced, each brake assembly should have its own…
Electric brakes have 2 wires located at the back. One is for power and the other is for ground (it doesn't matter which is used for which function). The ground wires should be connected to the trailer frame. The only other place that would carry…
Hey Karl, so as long as your current wheel bolt pattern is 8 on 6-1/2 inch you can mount a 17.5 inch wheel and tire like the Westlake 215/75R17.5 part #LHAS701. The width and diameter of this size is going to be right at the same as your 16 inch…
Trailer or automotive wheels can have a positive or negative offset. The offset refers to the distance between the mounting surface of the wheel that touches the hub and the center line of the wheel, as shown in the diagram I have edited for you. A…
Hi Dan, By torque I assume you have TorkLift turnbuckles, and there are indeed TorkLift frame-mounted camper tie-downs you can use with those. So long as you have the factory hitch on your 2005 Ford F-350, the correct tie-downs for your long bed with…
The Kenda 4.80/4.00-8 Bias Trailer Tire with 8 Inch White Wheel, #AM30040, is highway rated. Trailer tires have a speed rating of 65 mph. Trailer tires are designed for carrying a maximum load at all times, so to do that they are reinforced in the…
We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…
The Curt A-Series line is the premium version over the Q-Series line and comes with a few differences. One major difference being the jaw design for the A-Series, which overlaps itself instead of just butting up to itself like the Q-Series does. This…
As far as the mounting bracket, you can absolutely screw it directly to the hitch if you want. We do this frequently in our own installs and it will not compromise the strength of the hitch in any way. Now putting a few holes in the hitch does open…
At this point, you'll want to follow the physical wire from your connectors at the nose of your trailer all the way through the frame and body back to the left (driver's) side, checking its power as you go. It's really easy to do this…
The drop of the Curt Class V #C15810, which is the distance from the top of the hitch crossbar to the underside of the vehicle frame where the hitch mounting flanges attach to the vehicle is 5.63 inches. The distance from the face of the receiver to…
