Custom Fit 2000 Ford F-350 Super Duty Accessories

Your Curt #C15316 is for the deep drop bumper and has a measurement of just over 9 inches according to my contact at Curt. He said the #C15410 is 5.32 inches from the frame to the top of the crosstube and they don't have anything in between those…

The rails in the bed of your pickup are installed so that the king pin will be just forward of the rear axle when hitched. The mounting location is vehicle specific and if you would like to provide your trucks year, make, model bed length and cab…

If your Curt X5 Fifth Wheel Adapter #16310 was left in a hitch for an extended period of time is very possible that it seized up in the hitch. You would just need to apply liberal amounts of penetrating oil like WD40 around the shank of the adapter.…

Yes, you can definitely cut out parts of the BedRug Custom Full Truck Bed Liner so that you have access to the puck system for 5th wheel towing with your 2013 Ford F-350. The correct BedRug for your pickup depends on the following specs for your…

First you will want to install a set of 5th wheel rails using the Curt Custom Fifth Wheel Installation Kit #C16443-204 on your 1999 Ford F-250 Super Duty 4wd. This kit includes custom mounting brackets which greatly reduces any drilling required on…

If your rails are ISR (Industry Standard Rails) then yes, you can easily swap out your 16k sliding 5th wheel hitch for a Curt A20 5th Wheel Trailer Hitch w/ R20 Slider - Dual Jaw - 20,000lbs #C16541. An easy way to see if the rails are ISR is to…

For a 12-1/4" x 2-1/2" Dexter electric brake assembly you will need the following parts: Left Hand - 12-1/4" x 2-1/2" Brake Shoe and Lining for Dexter - item #BP04-236 Right Hand - 12-1/4" x 2-1/2" Brake Shoe and Lining…

I can provide a drawing for the Global Link RV Baggage Door Slam Latch, #295-000078. Please please see the attached image.

To separate the head assembly on the Curt A16 5th Wheel Trailer Hitch, #C16120 please note the linked manufacturers instructions. After pulling the pivot pin, you may need to use a rubber mallet to provide impact force loosen the assemblies fit.

Yes, the Happijac Qwik-Load turnbuckles are very similar to the Torklift Turnbuckles like the #TLS9529-2-LK so they would work fine.

The Replacement Installation Hardware Kit #57-236PK will allow you to reinstall the Westin HDX Grille Guard #57-2365 on your 2009 Ford F-250 Super Duty. We do have the Replacement Rubber Strips #57-0001 if your rubber strips are damaged or in need of…

No need to worry, Typically it's harder to remove the head after use. I double checked the instructions that I've linked for your convenience, and they state it is only the lynch pin and large pivot pin that need to be removed to remove the…