In-Depth Review of the Grease Cap, 2.44" OD Drive In with Plug Video

The Tru Ryde grease seals you mentioned, part #RG06-70 are indeed a replacement for the 10-036-00 Dexter seals. They would work great for your application.

To determine the correct E-Z Lube grease cap you are going to need to measure the center of the hub where the grease cap is going to fit (please see accompanying photo). The measurement will need to be very precise, so you are going to want to use a…

Hi William! Thanks for the picture of your axle tag. The correct bearing kit is the #BK3-200 with a 10-36 grease seal. If you want the Dexter version it is the #DX58ER, Are you getting your Momentum ready for spring/summer? Any big trips coming up?

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

Sounds like you are looking for a lower profile jack for your trailer so that the tailgate of the vehicle does not interfere with it. I went to our warehouse and was able to locate an a-frame jack that measured less than 12 inches from the bracket…

Hi there Joseph; thanks for the question and we do have what you need. The correct replacement dust cap for the Dexter Trailer Hub and Drum Assembly - 5,200-lb and 6,000-lb Axles #8-201-9UC3-EZ is the following: - 2-1/2" Lubed Dust Cap and…

Hey Mark, the only real downside to an offset ball like the Gen-Y part #GY43XR is going to be that it costs more typically and it would take up more room when stored compared to a non-offset ball like the #C38CR. The handling and weight carrying…

From our experiences the Harbor Freight trailers like yours have a hub bore that requires a cap or Bearing Buddy that measures 2.047 inches like the #BB2047 you referenced. We don't have a standard cap that fits this size so the Bearing Buddy is…

From the numbers you provided it sounds like you need replacement grease seals. In my research, the grease seals I found with the GS-1719DL number have a 1.72 inside diameter and 2.565 outside diameter. The replacement double lip grease seals you…

Since wheels will be able to withstand the psi rating of any of the tires that are meant to fit it you will need to look at the valve stem as that is the deciding factor. If your valve stem has the rubber all the way up to the threads, like part…

We can get you what you need unfortunately you will need to take some of the measurements to make sure you get the correct bearings and seals for your trailer. Trailer manufacturers use many different sizes when they build their systems and without…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…