2007 Ford Explorer Sport Trac Tool Box

Hey John, so the correct amount of spring bar tension will be based on the…

The OEM prep package consists of 4…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length…

Yes, the best option we can offer you to add fuel capacity is with the DeeZee Truck Bed Auxiliary Tank part #DZ91752X which should fit in the space you have between the cab and 5th wheel hitch no problem as it is only…

I got some information from Yakima and included a diagram of the EXO SwingBase #Y34VR, which is the base part for the EXO SwingBase 2 Tier #Y82VR. Though the measurement from the pin hole to the closest edge of the carrier is not included in said…

I attached a picture that shows the pin out diagram for the Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole #PK11893-11932 that you referenced.

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

We definitely have an option to get a tonneau cover working with the UWS UWS Truck Bed Toolbox #UWS00030 once installed on your 2022 Ford F-350 long bed. With that said, the Access Toolbox Edition Soft, Roll-Up Tonneau Cover #A61409 is specifically…

I have a great tool box option for your 2022 Ford F-250 that sits below the rails of your truck bed. The UWS Truck Bed Chest #UWS01048 is going to do a great job of wisely using the space in your truck bed while staying below the bed rails. It is…

The bolts on the Replacement Tongue for Yakima Exo SwingBase Swing Away Hitch Extender #Y26KV should be tightened to 100 Nm. This can be found on page 2 of the instructions for the Yakima EXO SwingBase Swing Away Hitch Extender -…

The pin box on your 2023 Heartland BigHorn 3970RL is a Lippert 1621. The Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY38FR will fit the bolt pattern but…

Best way is to drill a hole through the floor of the tool box and then through the bed of the truck and then run a bolt through both. This is the best way to secure a tool box.