2005 Toyota Tacoma Truck Tailgate Lock

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers part #PAL9772 or part #PAL9555 will work on the Leer 100XQ Truck Caps because it uses a cable latching mechanism and the handle is not riveted on.

I checked with Pop & Lock for you and there is a system that they have confirmed will work with 2011 and newer Leer 100XL, Leer 100XQ, and Leer 700: - Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard…

The Leer 100XR isn't specifically listed by Pop and Lock but more than likely the #PAL9772 will fit. It requires a frameless, bonded glass door with a 1-1/8" center hole for a rotary latch. This particular kit would…

The Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 will work on the A.R.E. MX series truck cap you referenced on your 2017 Ford F-250 Crew Cab Short Bed. This will give you a clean look along…

Pop and Lock does have the manual locking tailgate handle, #PAL5500, that will work with your 2015 Toyota Tacoma with backup camera. You can turn it into a power locking handle by adding conversion kit #PAL8525.

I do have an option for you to get the locks working again but we don't carry Load Lock so I don't have any advice or replacement parts for this. That said, you should be able to pretty easily replace this with the Pop…

The Bauer Products T-Handle Lock for Truck Caps #BA57VR comes with a J-327 key. So by ordering 3 of these they are all keyed alike. This particular handle is for locks rotating counterclockwise. We also have the Clockwise T-Handle #BA84VR if your…

The standard a-frame coupler degree is 50 degrees but we do have a 32 degree coupler with the part #DM15633-81 but the rear width of it is 9-7/16 inches.

Unfortunately, Atwood no longer has the repair kits available. They were bought out and the company that now owns them stopped producing the repair parts you need. I recommend the A-Frame Trailer Coupler - Yoke Latch #CA-5210-B for your replacement…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

According to Pop & Lock, the #PAL9772 should work on a Leer 700 truck topper with the existing handle. If for some reason the handle isn't working, you can swap out to a new handle that will work with your Pop &…

So long as you have the Leer 100XC truck cap, the correct Pop & Lock is the following: - Pop & Lock Power Lock Conversion Kit #PAL9772 I verified this with the manufacturer for you.