Spare Tire Covers Specs:
Features:
Extend the life of your trailer's spare tire by protecting it from the sun, dirt, grime, and road salt with this weather-resistant vinyl cover. Elastic-trimmed rear opening gives a snug fit and the vented bottom lets moisture escape.
More Information >Spare Tire Covers Specs:
Features:
Extend the life of your trailer's spare tire by protecting it from the sun, dirt, grime, and road salt with this weather-resistant vinyl cover. Elastic-trimmed rear opening gives a snug fit and the vented bottom lets moisture escape.
More Information >Videos
for Spare Tire Covers
Help Articles
for Spare Tire Covers
Expert Answers
for Spare Tire Covers
In order to replace the Advent Analog Wall Thermostat ACTH11 you'll need the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners part #ACRG15. This is a digital style replacement which is…
view full answer...For a pair of stabilizer jacks that would have more than enough capacity that would work well on your R-Pod I would recommend the Stromberg Carlson Trailer Scissor Jacks part #JSC-24. These have a 5k capacity per jack and would do a great job as…
view full answer...Your 265/70R17 size tire is around 31-1/2 inches in diameter. You want to make sure the tire cover you get is large enough and doesn't have to be stretched over the tire. I'd rather have one…
view full answer...Yes, you can replace your GE air conditoner with an Advent air conditioner like the Advent Air RV Air Conditioner #ACM150. Additionally, you will also need a thermostat. For that, you can use the Air Distribution Box w/ Built-In Thermostat for…
view full answer...Based on the information you gave, although I can't help with the axle (other than to state it is a 3,500 lbs axle). Dexter mobile home axles were designed for one time use and weren't really documented…
view full answer...The power circuit for each leg of the Lippert Ground Control leveling system #LC358590 is protected by a 35 amp fuse. That means that at most the entire unit could draw up to 140 amps at a time. Realistically it would probably be considerably less…
view full answer...There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…
view full answer...The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.
view full answer...Yep, you're exactly right; the distance from the center of the hitch pin hole to the welded gusset is indeed four inches on the Curt Ball Mount for 2" Hitches #C45112. So if…
view full answer...The biggest difference between the Tow Ready Tail Light Isolating Diode System #TR118821 and the Roadmaster Universal Hy-Power Diode Wiring Kit #RM-154 is that Tow Ready created their wiring kit with quick disconnects so if you ever get a new…
view full answer...It's totally normal for a bit of movement between any fifth wheel hitch and the base rails. The feet on the hitch are typically a bit smaller than the slots they slide into for mounting otherwise you'd…
view full answer...Actually our etrailer.com brand brake assemblies are rebranded AxleTek assemblies. So we have the 8k left and right assembly set #AKEBRK-8 which is most likely what you need but these are 12-1/4 inch in diameter by 3-3/8 inches wide and attach with…
view full answer...Filter Products (4)