Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Thank you for the photos and measurement! We have a variety of slide out wiper seals that might work for your application but you'll want to look underneath/behind the seals you have pictured to make sure they don't have any other kind of…
view full answer...The MB Sturgis Propane Pigtail - Stainless Overbraid - Type 1 x 1/4" Male Inverted Flare - 15" #100833-15 is an 1/4" inverted flare tip and your regulator requires a standard 1/4" NPT fitting. You just need a pigtail like Propane…
view full answer...Yes, you will need teflon tape rated for use with propane. The MB Sturgis Propane Hose Assembly - RV Type 1 w/ Back Check x 1/4" MPT - 12" #100473-12 does not have an inverted flare in it so it will require tape on the end leading away from…
view full answer...The Replacement Screen for Ventline Ventadome Trailer Roof Vents part #BVD0434-31 is used on the following Ventline models; V2092, V2110, V2094 and V2119. If you have the V2092, V2110, or V2119 then you'll need the Replacement Screen Frame with…
view full answer...It sounds like you are having an issue with the running lights on your trailer. If that is the case then since you have tested the trailer connector and found that power is not reaching this, you either have a blown fuse, bad converter, or shorted…
view full answer...There are a few troubleshooting steps to help you figure out why you have no power. I would start by making sure that there is not any corrosion or debris blocking your connection points. If they are clean or still no power after cleaning, I would…
view full answer...We do offer a wide variety of replacement lights for trailer but since trailer manufacturers don't keep a record of what they use on trailers I would need some pictures of the lights you are wanting to replace along with some measurements so I…
view full answer...We offer the necessary replacement pigtails in many lengths for rubber hose, you can use #37207-30755 for a 2 foot length, #37207-30775 for a 3 foot length or #CAM59183 for a 4 foot length. If you'd prefer braided steel hose for durability, use…
view full answer...Hey Paul, You most likely could still pull the trailer if you really needed to even though the shear spring #MR35UR needs to be replaced, I just would make it a short trip and get it swapped out. A bad shear spring can lead to a rough ride quality…
view full answer...I attached a chart that has the automotive cross reference for the Kodiak disc brake pads part #K2250CP that you referenced under the yellow heading. Probably the easiest to look up would be 1982 to 1992 Chevy Cavalier.
view full answer...The Stallion Jack brand is not directly compatible with anything we carry. The closest thing we have is the Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K #TJD-12000-RODNUT which is 3-1/2 inches x 3-1/2 inches. I…
view full answer...We do not have this item in stock for me to measure its thread pitch but two of us estimated it as being 6 or 7 threads per inch. I linked a photo of the instructions to replace this part. The bearing is removable and is available as a replacement…
view full answer...