Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Yes, you'd need to hold the inner jack leg while you remove the bolt from the bottom when replacing the Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System part #LC324269. In order to hold the inner jack leg, I…
view full answer...I suggest using a strap wrench to hold the cylinder side while tightening the installation hardware on the Replacement Foot Pad, #LC324269.
view full answer...The Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System #LC324269 doesn't have a specified weight rating. Since this is a direct replacement for a hydraulic jack that does have a weight rating, like the 8K Lippert Level…
view full answer...I've attached a little diagram below from the instructions of the Demco Air Force One Supplemental Braking System w/ Wireless Coachlink #DM26VR that shows how to wire your reed switch. In the 2-wire reed switch setup you will just run the…
view full answer...Since you have the SMI DUO #SM99251 currently all you need to install it in your 2009 Honda Fit is the part #SM6270 and you'd be set. For a base plate kit the Blue Ox part #BX2253 would be what you'd want with the Avail tow bar part #BX7420.…
view full answer...The G-Force Controller #DM78VR for the Demco Stay-IN-Play DUO Supplemental Braking System #DM86VR is what is used to switch on and off the braking system when you are flat towing or not. It also is used to adjust the braking sensitivity to ensure…
view full answer...Lippert does not offer a replacement inner jack tube for their jack 1817941. When a jack is damaged in this way (which is more common than you want to know) it really is best to replace the entire jack for safety reasons. The outer tube on your jack…
view full answer...I checked and found the manual for the Lippert Electric Trailer Jack #LC285318 and there was no mention of anything going in the hole beforehand to tighten them. I added a cut out of the manual for you which shows the parts for this jack, and it does…
view full answer...You will need the Bulldog Replacement Manual Override Crank Bolt Kit for Bulldog Powered-Drive Camper Jack, part #BD500191. This is a manual override crank bolt that is designed for the Bulldog Jack #BD500185. It does not include a crank handle. The…
view full answer...If your Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU Item #FR93FR is coming on and then kicking off you could have an electrical, gas, or water pressure issue. The unit needs to have 12v DC running to it so you'll want to…
view full answer...I attached a picture that shows about how much a slide topper typically hangs over a slide out when installed for you to compare to what you have. If you can get me the width of your slide out including the distance from outside of flange to the…
view full answer...What you're needing is the Replacement Override Nut #LC55FR Lippert Electric Trailer Jack #LC285318 (which is the same as the part #LC421366 that you referenced). I confirmed this with my contact at Lippert.
view full answer...Filter Your Search
Contact and Help