Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…
view full answer...To fit the Curt Q24 Head Unit #C16545 to the puck system on your 2022 Chevy Silverado 3500 you need the Curt OEM 5th Wheel Hitch Legs #CU53FR. Attached is a review video of the whole kit, part #C37FR, once you have the head and legs installed…
view full answer...Thanks for the photo! I had Lippert run the serial number from the photo, and was told that you have a Lippert 1621 pin box. The compatible Curt Flex Air cushioned pin box is part #LC328492 for an 18K or #LC369535 for a 21K capacity. However, the…
view full answer...The Lippert 1621 pin box #LC1191191 is 12-3/4 inches wide and has a measurement of 3-3/8 inch from the leading edge of the pin box to the front of the king pin. From the leading edge to the back of the pin box the measurement is 8-7/8 inches. This…
view full answer...No, the Lippert 1621 will not have any issues with an 8' truck bed. The trailer will just sit a little further back. I spoke to my contact at Lippert and they stated that the general rule of thumb for a truck with an 8' bed would be to use a…
view full answer...Hey Jay. It sounds like you are on the right track here because a sidewinder pin box will be your only option for pulling your 5th wheel since you have a short bed truck with the Rambox. That said, you are right that the Reese Sidewinder cannot be…
view full answer...The Curt A-Series line is the premium version over the Q-Series line and comes with a few differences. One major difference being the jaw design for the A-Series, which overlaps itself instead of just butting up to itself like the Q-Series does. This…
view full answer...The general rule is 5 or 6 inches clearance needed between the trailer loft and the bed rails is mostly to do with situations when the fifth wheel may take a deep dip like a pot hole or entering a steep drive. Without proper clearance the bed rails…
view full answer...If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…
view full answer...Yes. You will have to use the Demco Hijacker Autoslide Capture Plates for Trailair Rota-Flex Pin Boxes #DM6171 on your 2021 Grand Design Reflection 337RLS. As far as which Curt Flexair works for your trailer, it depends on what pinbox you currently…
view full answer...Normally the pin pulls right out easily. What you can do is try spraying lube like WD40 down into the hitch tube to see if you can get it let go. What could also be happening is that the base is binding up in the hitch tube. It may not be an ideal…
view full answer...The B&W Companion OEM 5th-Wheel Hitch for Ford Super Duty Prep Package - Dual Jaw - 20,000 lbs #BWRVK3300 is a confirmed fit for your 2017 Ford F-350 with factory rail kit for 5th wheel. This hitch weighs just under 150 lbs. It does come in…
view full answer...Filters
3455 results
Related Searches