Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Bob, I went out to the warehouse and measured the Brophy Stake Pocket Tie Down Anchor #TL1B and unfortunately think this one is going to be a bit too long for you. From the bottom of the tie down to the underside of the flange measures 8", 3…
view full answer...Yes, the Extreme Off-Road Swing-Up Jack w/ Dual Wheels iItem #ORJW500D will work for your T@B 400 Tear Drop Trailer. It looks like your trailer comes with an a-frame jack. You would need to ensure you have enough space on your tongue to accommodate…
view full answer...The CE Smith Roller Bunks, #CE27700, that you referenced would be a great option for your boat trailer. These roller bunks are 4 ft long and they can be mounted directly on top of your current wood bunks. You can also use the CE Smith Mounting…
view full answer...I did some research and found that the 2,600 lb Hub, #22834, takes the #1779 outer bearing and #2788 inner bearing and would use the #29031 grease seal. This hub has a 6 bolt on 5-1/2 inch bolt pattern. This sounds like the hub you have, and…
view full answer...The Optronics LED Clearance or Side Marker Trailer Light is available in Red #MCL0030RBB and Amber #MCL0030ABB. These are the closest replacements to the Glo Brite 122r/122y lights you have. The lights only have one LED diode versus the 3 in your…
view full answer...If the hub bore is 1.5 inches like you mentioned (the area of the hub where the cap installs) then we don't have a Bearing Buddy that will fit. If the measurement was more like 1.75 inch then the #BB1781 would most likely fit as it measures 1.78…
view full answer...This sounds like a ground problem on the right side. The turn signal not working makes sense because with the brake lights, there is a constant signal coming through which is enough to make the lights illuminate on both sides like they should. But…
view full answer...The controller would need to be hardwired to your C5500 motorhome as it would not have a harness under the dash using our Brake Controller Installation Kit, part #ETBC7. Due to the fact that your motorhome is longer than the usual passenger vehicle,…
view full answer...The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…
view full answer...The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.
view full answer...The exact replacement hub assemblies you need for your BD2-545-17 are the etrailer Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 #AKHD-545-35-K that you referenced.
view full answer...We don't have a tire in that exact size. We have ones that are close but not quite as wide. They would be about an inch skinnier like the part #AM10130. As long as you have a 12 inch diameter trailer wheel that is 4 inches wide this would work…
view full answer...Filters
- 2518 results