Welcome back Sean! The 2" receiver part of the MaxxTow Ball Mount item #MT70066 does not have it's own capacity. The entire ball mount has a 500 lbs tongue weight limit. What that means is you'll need to take the combined weight of your…
Most trailer wheels have a zero offset. This is because a zero offset allows the wheel to handle the maximum load by distributing the the load equally to both sides of the wheel. To determine if your trailer wheels have an offset, you will want to…
I did some research and found that the 12194TC seal you said you have measures 1.250 inside diameter, and 1.979 outside diameter. The seal I recommend is part #34823. The dimensions listed for this seal are 1.249 inside diameter and 1.983 outside…
Hey Matt, we have a topper from Fas-Top that fits the 8 foot long bed versions of the 2024 Ford F-350 with the part #FT63EV but the part #FT84MV only fits the short bed trucks and would not work for you. The Solo is just the topper whereas the…
The recommended distance between the hangers of the #APS1 would be 24-7/8 inches when using the leaf spring #e54SR. When the trailer is set on the ground and the leaf spring is supporting the weight of the trailer the spring will flatten out and get…
The opening width of the S-Hook on the Curt Single Hook, Coiled Safety Cables #C80176 referenced in your question is 3/4 inches and are not big enough to fit around the thicker side of the Curt Safety Chain Loops #C60618. These have a weight capacity…
It really depends on your setup, if the safety chain loops on your tow vehicle are spaced far apart then you will need more slack to make a tight turn then if they were closer together. What I would recommend you do is connect your trailer to your…
Hi Shane; sometimes the adapter module #HBA-CAM is needed to help the brakes function properly. However, before you go this route I would check out the brake controller. More often than not you need to switch to electric over hydraulic mode for the…
To determine if there are compatible hubs and associated bearings to replace your current hubs to a more standard size you will have to take several precise measurements on the spindle of your axle. It is recommended to use a set of dial calipers to…
Hey Markell! The B&W Anti-Rattle Clamp for 2-1/2" Hitch Receivers #BW65FR is not compatible with any weight distribution hitch so it can't be used with the Andersen. With that gusset welded on the shank I recommend the Roadmaster Quiet…
Filters
