I reached out to my contact at Redline who said that there shouldn't be any issues with using the 2-1/2" Long Torx Trailer Floor and Wall Liner Screw for ACQ Treated Wood #TFX250ACQ to secure your AC2 treated boards to your pontoon trailer…
I would go ahead and use the same holes that are already on your trailer. just make sure that they are the 7/32" diameter needed for the 2-1/2" Long Torx Screw #TFX250ACQ and that they have a good grip. If the screws don't seem to hold…
For a Bulldog 180 series jack you will need replacement drop leg pin #BD500177. It includes the spring, cotter pin, and washer. You should not have to remove the inner drop leg to replace the pin and spring. Start by pulling back on the pin. Then use…
The modern size equivalent of the 20.5x8-10 that you have currently would be the same size tire that is on the #AM3H340 that you referenced, 205/65-10. As long as the bolt pattern of your current hubs are 4 on 4 inch the wheels of this would bolt up…
I recommend the treated torx screws for treated wood for better corrosion and rust resistance. The treated torx screws like the Redline 2-1/2 Inch Long Torx Trailer Screw for ACQ Treated Wood, part #TFX150ACQ, are plated with a material that will…
In order to retain your current suspension geometry, you'll need to use an equalizer of the same length and height as the 7-3/4 x 2-7/8 equalizer you currently have. The Dexter Axle #K71-449-00 offers equalizers that are the same width and height…
The "Trailer Disconnected" error message on the dash with a factory brake controller is usually related to an issue with the blue brake output wire that runs from the brake controller to the 7-Way connector. The fact that the issue remains…
You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…
Your outer bearing, LM12749, is not a trailer bearing that we carry at this time. I checked online and found that the outer bearing you need will have a 0.8656 inch inside diameter for your spindle. The #BK2-100 Bearing Kit is definitely not the…
The longer 2-1/2" torx screw Item #TFX250ACQ will work the best to attach the boards to the metal frame of your Big Tex trailer when replacing the trailer deck. If you need a torx head screwdriver bit, you can use part #TX430-1.
The only way to know for sure the capacity of your axle is based on the information from the manufacturer when the axle is new. Typically, 1-1/2 inch square axels have a capacity somewhere between 1,000 - 2,000 pounds. Sometimes the spindle and hub…
You have the dreaded, no longer available Atwood surge coupler on your trailer. Since Atwood was bought out and the production was stopped on the actuators there are no replacement parts for your actuator. There's no easy way to lock that coupler…
Filter Results
