Hey Rich, I checked with Vitrifrigo and the easy way to determine if the fridge has the Next Gen R600a compressor is if in the title of the fridge there is an HP or a CHR. So for a mini fridge we have the part #VT69FR, for a mini fridge with a…
Hey Patrick, thanks for reaching out. Yes, the Replacement Front Jack Leg #LC362485 should work for your 2021 Open Range 314RLS with the Lippert Ground Control 3.0 system. Since your weld stop “bump outs” measure 17-1/2" apart, that matches the…
Hey Eddie, the Curt hitch part #C22RJ and the Trailermate part #TMT29FR are both very similar in design and capacity. I really like the Curt hitches and recommend them whenever available but Trailer Mate isn't bad either. If you are wanting the…
For your application you need the Pre-Greased Easy Grease Trailer Hub and Drum Assembly #AKHD-655-35-EZ-K. This matches all of the specs you mentioned and while it's only rated for 3.5K axles, it will still work for your Lippert 4.4K axle since…
I reviewed all of our trailer wheel bolt inventory and did not have a match for your request. I also contacted our suppliers and was not able to make a match there. The bolts I found were not 13 threads per inch coarse, nor left-handed. I suspect you…
According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…
There isn't a way to add-on a pintle adapter to the B&W Tow & Stow Ball Mount #BWTS20040B, but B&W does offer a pintle hitch specific Tow & Stow ball mount for a 2-1/2" hitch with a 2" ball #BWTS20055 and a 2-1/2"…
There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…
There should be enough free play in the shackles to allow them to move. There is no specific torque rating for shackle bolts. The first thing you should make sure of is that the bolts you use are long enough so that when installed you will have at…
On a 2007 Ford F-150, you should not need to remove any panels. It should be right by the center section of the dash, by the radio. Go back towards the firewall, and you should find it to the right of the gas pedal arm, but closer to the driver than…
I attached a chart that has the automotive cross reference for the Kodiak disc brake pads part #K2250CP that you referenced under the yellow heading. Probably the easiest to look up would be 1982 to 1992 Chevy Cavalier.
It sounds like you are definitely on the right track here. The #MR79ZR is indeed the correct suspension upgrade kit for your 2007 Colorado 5th wheel with LRE suspension. Moryde makes a fantastic suspension upgrade kit. The heavy duty shackles and wet…
Filters
