Hey Mike, thanks for reaching out. No. The RV Designer On/Off Wall Switch with Bezel and Plate #RD43VR is only available with a standard, non-illuminated rocker switch. If you're looking for the same functionality with an illuminated switch, RV…
John, that's a great question, and honestly, I wish more manufacturers published those details up front because they can make a big difference when planning an installation. I reached out to PowerMax and was able to confirm that the pre-wired…
The Yakima HoldUp you referenced isn't a good choice for bike with fenders. The ratcheting hooks can't be tightened enough to get a good hold on the front bike wheels. For bikes with fenders a better choice would be one of the following bike…
I pulled one of the Ball Mount Adapters, part #BA-1 from our warehouse and took a measurement for you. As the attached photo shows, the center-to-center measurement is 2-1/2 inches. With 3 inch spacing on your shank this will unfortunately not work…
The MB Sturgis Propane Adapter Hose - 3/8" Male NPT x 1/2" Female Flare Swivel uses a 3/8" fitting on the regulator side and 1/2" fitting on the manifold side. These are nominal fitting sizes so they don't actually measure…
The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…
I can see from your image you do have a 205/75R15 tire but I am unable to make out the exact load range for the tire. We have the Karrier ST205/75R15 Radial Trailer Tire in a Load Range C #AM10244(1,820lbs) or Load Range D #AM10245(2,150lbs). Be sure…
E-tracks are typically the stronger of the two, but X-track is more versatile since you can mount them horizontally or vertically. Choosing between the two really depends upon how you plan to use them. If you are installing something in a truck bed,…
When installing the Ventline Vanair Trailer Roof Vent #VP-543SP a passive inlet vent such as #HMAV2-AVT2 certainly would not hurt though it is likely not necessary, though it would be difficult to say for sure without knowing the rest of your…
If you have 12 volt lights in your trailer that you are wanting to power with your trailer's battery all you need to do is run the power and ground to the battery. When your tow vehicle is connected they will either be powered by the 12 volt…
I have attached a photo for you that shows how a 7-way trailer connector is wired. If you take a look at the trailer side trailer connector you will see a terminal labeled "12V Power". If you were to run a wire part #10-1-1 (per foot) from…
Filters
