Result: E4541

Hey David. The CMB-133-7XL corresponds to a mounting bracket that is designed for a Kodiak 13" disc brake system that fits a #42 Spindle. That spindle is commonly used with 7,000 lbs and 8,000 lbs axles. Which means you'll need the Dexter…

The Dexter 8-283 is an obsolete 2800lb 10 x 1-1/2 inch hub that used a LM67048 inner and a L44649 outer bearing. Unfortunately, we don't have any hubs that would be compatible with the spindles on your axle. Your best bet at this point would be…

Electric drum brakes such as the Dexter #23-439 that you referenced should always be adjusted so that there is a slight drag on the hubs when you rotate the wheel by hand. You should be able to hear and feel this slight drag when the brakes are NOT…

It sounds like you have already done a lot of troubleshooting and your brakes are adjusted properly each time. You certainly shouldn't have to be adjusting brakes like the #23-26-27 every 300-500 miles. The first thing I would check is the wiring…

Hey Ben, yeah it sounds like your trailer has a 3,500 lb capacity axle based on what you mentioned so the correct disc brake kit part #T2HRCM10DAC that you referenced does fit.

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

I spoke to my contact at Kat's and they informed me that the Kat's Heaters Handi-Heat Magnum Magnetic Heater part #KH1190 draws about 3 amps of current.

We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any damage…

Hey Chris, it looks like the 2025 Ram 1500 does use the same brake controller install harness as previous years so you could use the part #RED87CR which is a Redarc Tow Pro Liberty and the custom fit harness for your truck. We REALLY like the Tow Pro…

Shane, sorry to say we don't have a replacement hardware kit by itself for the B&W Turnoverball #BWGNRK1313. The hardware actually does not look like it's offered by B&W themselves, unfortunately. What I did instead is attach a…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

The Installation Instructions for the Convert-A-Ball Cushoined 5th-Wheel-to-Gooseneck Adapter #CAB-C5G says to tighten down the cap screws to approximately 100 ft. lbs. Keep in mind that you will need someone to help hold the adapter while someone…