Troubleshooting Dexter Electric Brakes Overheating on Rear Axle of Tandem Axle Trailer
Updated 01/14/2022 | Published 01/10/2022 >
Question:
Help me figure out how to get them properly adjusted and then stay that way. Presently I adjusted them all tandem axle trailer to very slight lining/drum drag. After a few hundred miles the rear axle hubs will be very unpleasantly HOT to the touch. The trailer is towing level, is not overloaded, and the bearings are okay. Castle nut has proper tightness. I will literally have to jack up the trailer, remove the combo hub/brake drum, adjust the starwheel cannot access it from back because of axle configuration, repack the wheel bearings and replace all. After 300-500 miles, I have to repeat process. Once I tried just driving a bit slower as I sought an emergency pull off and after 50 miles the hubs were cool to the touch again. They are getting hot enough drums/bearings that they are becoming discolored so this is not just that I had laid on the brakes a lot and then immediately checked them to find them very hot. It was after 100 miles at 70 mph with only minimal highway braking I pull over on shoulder to check hub temps every 100 miles now. The front hubs are remaining cool to the touch. ALL brakes lock up when the trailer is jacked up and brakes are applied. Thanks for any help you can give me. Dexter has been less than helpful.
asked by: Gregory J
Expert Reply:
It sounds like you have already done a lot of troubleshooting and your brakes are adjusted properly each time. You certainly shouldn't have to be adjusting brakes like the # 23-26-27 every 300-500 miles. The first thing I would check is the wiring for your rear brake assemblies. Make sure the power and ground wires have a good connection.
The other thing I think this could be is the axle/spindles. It is possible you have a bent spindle or axle which could result in suspension issues and overheating. This would also make sense since you are only experiencing this problem on the rear axle brake assemblies and not on your other brakes. I would check the tread on the rear tires to see if you notice anything abnormal.
Product Page this Question was Asked From
Dexter Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3.5K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Manual Adjust
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Search Results: e4541
- Search Results: 10k brake
- Search Results: dual wheel
- Search Results: breakaway kit
- Search Results: hasp
- Search Results: kti remote
- Search Results: safety chain
- Shop: Spring Trailer Axle w/ Electric Brakes - 5 on 4-1/2" Bolt Pattern - 93" Long - 3,500 lbs
- Shop: Dexter 3/4" x 4-1/2" Spring Eye Bolt for 10K General Duty Slipper Springs
- Shop: TecNiq Low Profile Third Brake Light - 15.5" - Red Lens
- Shop: etrailer Electric Trailer Brakes w/ Dust Shields - Self-Adjusting - 12-1/4" - Left/Right - 10K
- Shop: ThinLine LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 15 Diodes - Clear Lens
- Shop: Dexter Trailer Brake Drum for 9,000-lb to 10,000-lb Axles - 12-1/4" - 8 on 6-1/2 - Non-ABS
- Q&A: Rear Axle Brakes on Tandem 5th Wheel Trailer Run Hotter Than Brakes on Front Axle
- Shop: Electric Trailer Brake with Dust Shield - Self-Adjusting - 12-1/4" - Right Hand - 10,000 lbs
- Video: The Low-Down on the Lippert Replacement Hydraulic Cylinder for RV Slide-Out
- Q&A: How Thick Are Electric Brake Shoe Pads and When Should They be Replaced
- Shop: Suspension Enhancement
- Video: Feature Breakdown: Replacement Wet Shoulder Bolt
- Article: Trailer Wiring Diagrams
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Bearing Kit for 2017 Jayco Jay Flight 17BH
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Why am I Only Getting 6 Volts of Power Back at My New Dexter Brakes, but the Full 12 Volts at 7Way?
- Q&A: Looking For Trailer Brakes And Hubs For Dexter RT 3,500 lb Axle
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers

