Result: 2953

To run a charge line to your battery you will first need to install a 7-Way on your trailer. This can be done using the Epicord 7-Way Molded Trailer Plug with Junction Box #277-000141. The Black wire in the junction box is the one that will carry the…

Wheels with a 4 on 4.5 bolt pattern are typically found on old passenger vehicles. We have found at least one instance where they were on old trailer from the 60's, but in general that is not a bolt pattern found on trailer wheels. Since these…

I do have an option that will work for you, but the closest we can come to a standard axle with the same measurements you provided is the Dexter Trailer Axle Beam with EZ-Lube Spindles - 89" Long - 3,500 lbs, part #T3584F-EZ-8974. The hub face…

We do carry the Dometic RV Water Heater #DMC74FR which you could use to replace your Atwood G6A-8E 6 gal RV Water Heater, but I highly recommend switching over to a tankless system like the Furrion RV Tankless Water Heater 60,000 BTU #FR98SR. This…

We have not yet (as of April 2019) had a chance to install any wired trailer brake controllers on a 2019 Ford Ranger so for guidance I checked with my most trusted brake controller expert at Tekonsha. Based on what I could learn about the truck if…

Hey Tim, The ZCI Circuit Protected Vehicle Wiring Harness #119250KIT is compatible with LED lights and has been used as a go to for years for people who have LED trailer lights. The light function is supposed send a tiny bit of voltage from the…

The 125255UC seal has a 1.249" ID and a 1.983" OD and for that our part #34823 will be the correct replacement.

Though I may have an option for you, I was also unable to find any info on the T-23972 seal you currently have. With that being said, the Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2 #RG06-050, or #58846 as…

You are correct and the linkage does need to be replaced. For that you would want the part #LC379160 which matches what you have. My contact at Lippert technical confirmed that two washers, not four, are supplied with the Kwikee Step Gear/Linkage…

This Hopkins wiring harness does fit your 2019 Toyota Highlander. Since the location of the factory wiring is located inside the car and not under/behind the bumper, you will likely be limited to the current location of the wiring. That being said,…

I was able to find the same information as you in the owners manual for your 2022 Chevrolet Blazer that states the 4 blunt wires behind the headlight switch. I was able to find where one person found the wiring near where the brake pedal mounts(see…

I do have an option for you but we have not yet gotten out hands on a 2019 Chevrolet Blazer therefore, have not had the chance to look for the brake controller wiring port either. I checked with both Tekonsha and Curt and it looks like they have not…