Result: 13392

Hey Tyler, thanks for reaching out. I'm sorry to say no, we don't have a 5 on 4-1/2" hub, or any hub for that matter that fits a 3/4" straight spindle. That kind of spindle was really only seen on older trailers and is basically…

Most brake actuators for drum brakes like your Dico 6000 lb cannot be used for disc brakes. This isn't based on weight capacity, but rather based on the pressure the master cylinder can handle. Most drum brake systems give you 1000 to 1200 psi,…

Hi Joshua; you can respond to the email that had the link for this page if you want to send me the video. It does sound like it is the actuator, could be the shock in there or the master cylinder. It would also be worth checking to see if the brake…

If you have already added the fuse and the trailer charge circuit is not activated in the 2019 Ford F-350 Super Duty with factory integrated brake controller, then you want to make sure the trailer is connected and you press the brake according to a…

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

Hey Ben, yeah it sounds like your trailer has a 3,500 lb capacity axle based on what you mentioned so the correct disc brake kit part #T2HRCM10DAC that you referenced does fit.

No, it will not Bryan. The Redarc Tow-Pro Link item #RED57AR requires a USCAR port that comes with factory tow packages. The Stealth Hitches Hidden Trailer Hitch Receiver w/ Towing Kit item #SH25VR, that fits your 2023 BMW X5, does not have this…

I do have some options for you but there isn't a plug under the dash for a trailer brake controller on a 2023 Chevrolet Traverse. Therefore, if you want to use a traditional dash mounted trailer brake controller you must hardwire which requires…

Hey Jeff! If your current lines are in good shape, you can just add a T-fitting and run lines to the second axle, no need to replace the main line. Your actuator and line size are already designed to handle multiple calipers on a tandem setup like…

Hey Stacy, it's definitely possible to install an aftermarket brake controller like the Prodigy P3 part #90195 in your 2021 Ram 3500. To do this you will have to disconnect the ITBM (Integrated Trailer Brake Module). Doing so will turn on a…

The Replacement Strike Plate for Bauer Products RV Door Locks #BA29VR measures 3-7/8" long x 1-1/8" wide so it can be used to replace your current striker, but you'll have to accommodate for the slightly longer length. Our other options…

The plug-in harness should be located behind the appearance panel on the driver side. To get to it, you will just need to remove the two screws holding the panel to the vehicle. Sometimes these plugs are taped to other plugs so when you loosen the…