Hey Aaron, for 15 inch trailer wheels the recommended torque value is 90-120 ft lbs for the lug nuts. This is true for the Lippert lug nuts part #LC63ZP that you referenced as well.
I am sure we do but Big Tex does not have any kind of database to show what replacement parts fit their trailers. I would be happy to see if we have studs that would work for your hubs, but first I will need to know a few measurements of your current…
There are centric rings you can find which will allow you to mount a Wheel #AM20790 having a 4.88" pilot diameter on a axle designed for 4.77" pilot holes. You will need to locate these centric rings as they are not something we currently…
Hey Robert, I found the hub you mentioned and it's actually not a Lippert hub it's made by AP and it's a 7k axle hub with a 9/16 inch diameter wheel stud. The drive in wheel stud part #7-132 could work for you since it is a 9/16 inch stud…
A keen observation indeed, Brett. The mounting hole spacing on the Square D-Ring Tie-Down Anchor #ABS69FR is 3" horizontally and 3-1/4" vertically. I edited a picture for you to help illustrate.
Hey Mike, we have a similar hub that does fit a 12k Dexter dually hub with the part #8-214-8UC1. The 10k part #8-214-5 does have same bearings and seal so it would fit technically but it would not be weight rated for a 12k axle. For a drum you would…
There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…
The hub that you are looking for comes in the Trailer Hub Assembly #8-91-05UC1 on our site. For the E-Z Lube version you would instead want the Trailer Hub Assembly #8-91-05UC1-EZ. I contacted Dexter Axle and confirmed that these were the correct…
According to my contact at Bulldog a replacement plunger pin assembly for their landing gear set #BD500170 is not offered as a separate replacement part. However we offer the Stromberg Carlson Pull Pins #LG-119113 that also have a 3/8-diameter pin.…
I attached the chart you referenced and it states that when you use a #e54SR spring with a hanger kit part #APS3 the hanger distance should be 24-7/8 inches. The length of a spring when new and not installed on a trailer will be slightly shorter than…
The Taskmaster Steel Dual Wheel #TA29MR is our only 17.5 wheel with the 10 on 8-3/4" bolt pattern. We do also carry this wheel in the following wheel and tire packages. Provider 215/75R17.5 Radial Tire w/ 17-1/2" White Dual Wheel #TA56MR…
Filters
