Result: knobs

Have power at the controller, no lights at the knob. | Have power at the controller, no lights at the knob. | I would start by using a hook probe tester like the # PTW2993 to check and see if you're getting a power feed on the...

I like the concept of lockable anti rattle knob like those on Thule rack. Can the knob on Kuat Sherpa be replace to lockable knob like below or the kind ? | I dont really trus the lockable...

To install the rack into your hitch you will place the black hook into the pin hole of your hitch, tighten the anti-rattle knob until the rack is secure, and lock the knob with the provided key. | How easy...

In some of the videos I have seen, you are suppose to turn the bike clamp knob until you hear the clicking sound. Although the clamp is cushioned and If I where to turn the knob until it clicks, will this this clamping force be large enough to damage carbon framed bikes? |

Is this knob the ground connection or what is the difference between the adapators that do or dont have this knob? | I have a 2003 4 Runner with tow package the factory hitch connection is 7 flat. I have a...

To level the sensor, you will set the power knob to maximum by fully rotating it clockwise (with the trailer connected). | Light on controller goes from green to a light green. No assist. Will not adjust with the riflght diel....

I interested in 2 products I like on your page. Thule2 pro: The knob on the bottom that makes the rack snug in the hitch, when tightened is it enough to prevent big rack theft? | First I love your website. I interested in...

I made you a short video that shows how to replace the knob provided that the little tabs on the back of the knob or where they mount are not damaged. | While installing and checking operation, as I activated...

You are going to want the Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional # RED52VR, don't forget to grab a Universal Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob # 331-TPSI-001 for one of those empty spots on your dash. |

This should solve the issue with your adjustment knob and still give you clearance. This is the shortest length adapter we carry that will give you that additional ground clearance to protect your adjuster knob on your Kuat NV # NV22G. |

The metal ball will not respond to turning the knob. I cannot get the bike rack off the hitch. | The metal ball will not respond to turning the knob. I cannot get the bike rack off the hitch. The rack was put on too...

As a test I held the P2 at no upward angle in my hand and applied the manual power knob, with no increase / improvement in braking power. | Hello eTrailer. I recently installed the Prodigy P2 Brake Controller on my 2017...

If you didn't tighten the threaded hitch pin or the hand knob (whichever you have) then that would explain the wobble that you are experiencing. | I have a hidden hitch installed on my subaru crosstrek, I recently purchased...

Once in the trailer hitch you will spin the knob until the rack is tight inside the hitch. Then using the included key you can lock the knob so it will only free spin to deter theft. | Ive been looking at...

Check to be sure that the power knob is not set all the way to the lowest position. | I just hook up a pilot controller and if i hit the break pedal the dot in the middle lights up, but if i use the button on the controller...

Now for installing the knob of the controller you will need to pick a spot that you have at least 3/4" clearance for the knob, and 1-3/4" space behind the location for the back part of the knob to have enough clearance. |

That knob is a really nice option for a front hitch with a hitch pin hole that is recessed back by the front bumper. | I have just mounted the front 2 inch receiver hitch on my 3500 2021 ram that I purchased from E-Trailers....

When you mention the metal ball not allowing a fit it means you need to turn the knob counter clockwise to loosen the hitch cam. | I have a 2018 Subaru Outback with a u-haul 2” receiver. I attached the adapter that came with...

It has a manual slide, a power knob on the right and another knob on the left. | Its a Journey model # 527408045 approx. 7 yrs. old. I lost my manual and want to set it up for a new trailer. Is there a manual...

Also no lights on the control knob! | How do you make the brake controller think it is connected to a trailer with brakes? Just to make the unit light up. I have no lights on the control knob. I do lights on the tester for...

Then rotate the Level Knob clockwise until you see a shade of orange on the light. | I have the four wires hooked up, have power to the controller. But it doesnt go from green to orange/red when I try leveling the sensor....

The main unit measures 3-3/8" long x 3-15/16" wide x 1-1/8" tall and the control knob measures 2-3/8" long x 3/4" wide x 7/8" tall. | Im interested in Redarc Tow-Pro Elite # RED44FR because the control can be hidden and placed...

This is with the power knob all the way clockwise. Thanks | My green light looks like its on with trailer disconnected but when my trailer is connected the green light is much brighter. Also, I was trying to adjust my level...

The Sherpa 2.0 even comes in your choice of colors: - Gray: Kuat Sherpa 2.0 Bike Rack # SH22G - Black: Kuat Sherpa 2.0 Bike Rack # SH22B - Pearl: Kuat Sherpa 2.0 Bike Rack # SH22P One of the best things about the Sherpa 2.0 is how it installs in your hitch, doing so with a simple turn of its knob. The knob also works as an anti-rattle device so the rack (and your bikes) stay stable and safe. |