Rio x > R1T x > R1S x > Matrix x >

Result:

Products
Videos
Articles
Questions

Location of Fill Ports on Valterra RV Water Tank

How can you fill this? I don’t see a fill port. Or does it require a pressurized water supply? | Hi Elliott; the Valterra RV Water Tank # R8048 has three 3/8" threaded fittings on each end of the tank. You can see them in the attached picture,...

Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22

Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...

Tonneau Compatible Ladder Rack For 2025 Rivian R1T With OEM Tonneau Cover

2025 R1T I am 5 4. looking for a ladder rack options the work with the Rivian Tonneau cover that rolls with the bed rail button. and the tail gate button and also the side cargo buttons. please help with information and options. | Hey Dave,...

Availability of a 2 Trailer Hitch for a 2004 Toyota Matrix to Carry a Bike Rack

hoping this exists. Mostly need for a bike rack, would rather not use a converter. thanks | You are definitely on the right track when it comes to not wanting to use an adapter for your bike rack. The only trailer hitches that are a confirmed...

Recommended Wiring for RedArc BCDC Charger Used for Auxiliary Battery to Power Inverter

I have the DUAL INPUT 40A IN-VEHICLE DC BATTERY CHARGER by RedArc. What else do I need to set up a dual battery syatem with solar to charge a fridge in the trunk of my SUV, a few led lights, some charging ports for phones and accessories? What...

Bolt Sizes for a 2006 Toyota Matrix Trailer Hitch 24812

Do you know the size of bolts for 06 toyota matrix tow hitch? | All of the hitches available to fit your vehicle are Class I hitches. The most common hitch, 24812, was one which fits with or without the rear fascia. The bolts for that hitch...

2008 Toyota Matrix Trailer Hitch and Bike Rack Recommendation

I was hoping to find a 2inch tow hitch for my 2008 Toyota Matrix base model. My bike rack is 2x 2inch and I was hoping not to use an adapter. All the hitches that I have found thus far have 11/4inch receivers. | Only the larger vehicles like...

Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?

For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...

Installation Steps For Installing That Kat's Block Heater # KH11812 In A 2012 Kia Rio 1.6L Engine

Looking for block heater 2012 Kia Rio 1.6. Engine ,manual , 5 door . Send proper part and install instructions… want to know what I’m doing befor I start | The correct block heater for your 2012 Kia Rio 1.6L engine is the Kat's Heaters Custom...

What Size Bolts are Used to Install a Trailer Hitch on a 2010 Toyota Matrix

what is the bolt size , 12mm 1.25,1.50,1.75? thanks | If you look at the instructions for Curt hitch # 12228 which I have linked for you, the bolt size used is M12-1.25 x 30mm. This is a 12mm bolt. This is the size that fits the factory weld...

Recommended Metal Weld on Fender for a 12" Wheel

i need to replace my axle/ spindle. my bearing size is L44649. in and out its is 5x4 1/2 i assume spindle replacement will be p.n tru44fr i need 1. 2 spindles 2. axle tube or what size to get from the metal shopthis is on a jet ski trailer...

Are Load Resistors Needed for LED Backup and Brake/Tail Lights

Im thinking of changing to LED lights. 2010 Toyota Matrix XR . Do you need Load Resistors for backup and brake/tail light LEDs. What would be the cost from you for LEDs. Canadian Vehicle | When changing from incandescent or halogen type bulbs...

Will Maxtrax Mounting Brackets Fit Rivian Cargo Crossbars

Will this fit Rivian Cargo Crossbars? | Hey Philip, thanks for reaching out! The Maxtrax Mounting Brackets # MA92PR were designed around the Rhino-Rack Vortex crossbars so as long as the T-Slots for your Rivian crossbars are similar to the...

Would Thule Hullavator Work With Rivian R1S OEM Roof Rack?

Im trying to install the Thule Hullavator on a Rivian R1S. I already have the Rivian Cargo Crossbars so Id prefer to use these if possible. The Hullavator requires the crossbars to overhang and the Rivian Crossbars dont. Is there a way to stackinch...