Result: trailer wheel studs

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Ron, thanks for reaching out! According to my research, your Grand Design has 7K axles and matches with the Bearing Kit #BK3-200 which comes with a grease seal that has a 2.250" inner diameter. Is there anything else you're needing to…

Hey Roger! Assuming your hub uses the standard 7k bearings we have the Timken 14125A #TMK54FR and Timken 25580 #TMK44FR. If you have the original Dexter hubs on there it is safe to assume these are correct. If you're looking for a full bearing…

You can use the Timken Grease and Oil Seal #TMK98ZR in place of the Grease Seal #GS-2250DL. While they are not exactly the same seal construction it is still a double lip design and the dimensions are the same so they are going to fit correctly.

I attached a chart that has all of the recommended lug nut torque specs for trailer wheels. Based on your studs being 1/2 inch, your wheels being 15 inches in diameter, and your lug nuts being coned you would want to torque your lug nuts to 90-120 ft…

It is possible to replace your 62" long axle with a longer one. Our next size up is going to be a 72" long 2K rated axle like part #e32GR. The axle being 72" across measured from hub-face to hub-face. This axle comes with 5 on…

Hello Brett, I am sorry to hear that you are having a difficult time finding this leaf spring. We do not have anything that is rated that low in a 2" wide. In fact we only have 2 different leaf springs in 2" wide and neither are even a…

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…

Hey Donald. The Dexter 072-032-00 is a 26-1/2" long slipper spring, with a hook end, 5-leafs, that works with a 7,000 lbs axle. Our closest option to replacing this spring is the 5-Leaf Slipper Spring for 7,000-lb Trailer Axles - 26-1/2"…

Hey David, great questions! The Under-Bed Rail and Installation Kit #RP67KR comes with both the 30183 and 30924 parts of the hitch system and are the same as the Ford OEM puck system. All you need is this kit and you'll have the 4 pucks and…

The correct wheel stud for a Dexter 7K Axle with 1/2" Wheel Studs is the Dexter Wheel Bolt part #7-262 which is cross-compatible with the AL-KO 1530093.