Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22
Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...
Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?
For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...
Would Thule Hullavator Work With Rivian R1S OEM Roof Rack?
Im trying to install the Thule Hullavator on a Rivian R1S. I already have the Rivian Cargo Crossbars so Id prefer to use these if possible. The Hullavator requires the crossbars to overhang and the Rivian Crossbars dont. Is there a way to stackinch...
How to Tell if Power Mountain Tallboy Off-Road Bottle Jack Will Work with a 2023 Rivian R1S
what jack can you recommend for changing tires on my Rivian R1S 2023 and Intech Sol Dusk Rover off road package travel trailer? Will the Tallboy pm34fr work with a Rivian puck? | Hey Darin, thanks for reaching out! The Power Mountain Tallboy...
Will etrailer Spare Carrier # e98ZR Work with Rivian R1S 20
Does this fit a rivian r1s 20 inch all terrain tire? 275 / 65 / R20 | Hey John, yes the etrailer spare tire mount part # e98ZR that you referenced will work with the wheel and tire Rivian R1S 20 inch all terrain tire that you referenced. |
What Diameter Hitch Pin Is Designed for 2 inch Curt Hitch
What is the required diameter of the hitch pin to fit this hitch receiver? | Hey Paul, the Curt hitch part # C13098 was designed to be used with the standard hitch pin diameter for 2 inch hitches 5/8 inch like the part # PC3. |
Wiring Needed to Install Tekonsha Prodigy P2 Brake Controller on 1996 Isuzu Trooper
Dear Customer Support, I purchased from you 7pin ETBC7 kit for my Isuzu Trooper 1996 and as I am starting to lay everything out, i realized this kit is for the standard trailer config and not the RV trailer, which has a different wire color...
Solution for Installing Trailer Wiring on a Vehicle with Separate Turn Signals from Brake Lights
I have a 1995 isuzu trooper. The previous own wired in a trailer brake control and a 7 way connector. None of the lights and or brake controller were wired in correctly, I rewired the brake controller and the 7 way connector so now I have trailer...
Do the Yakima Replacement Bolts Come w/ Nuts?
Do the Yakima 2 1/4 bolts come with the nuts to tighten on the ski rack, bike rack etc.? | Thanks for the picture! The Yakima Replacement Bolts - 1/4" x 2-1/4" item # Y80011 do not come with nuts. However, judging by the parts you have in your...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Where Does a Trailer Wiring Harness Install on a 2001 Isuzu Tropper
Do I have to remove the wheel well or tail light to find the plug in? | Trailer wiring harness # C55339 installs in a factory wiring harness located on the driver's side of the back of your 2001 Isuzu Trooper. The factory harness should be attached...
Does Draw Tite #65004 Front Mount Receiver Fit 2001 Isuzu Trooper LTD?
Hello, I just was given the part# 65004 for a Draw Tite Front Mount Receiver for my 2001 Isuzu Trooper LTD. The mounting instructions says that is for Isuzu Hombre. Could you verify if this receiver is a front mount receiver and will for sure...
Surco Safari Rack 5.0 Rooftop Cargo Basket Recommendation for 1994 Isuzu Trooper
Can the Surco Safari Rack 5.0 Rooftop Cargo Basket SP S4550-1101 fit a 1994 Isuzu Trooper with Factory rails front to back? See attached pic. Thanks! | There is a Surco Safari roof rack option that I can recommend for your 1994 Isuzu Trooper...
Location of Vehicle Side Connection Point for Trailer Wiring Harness Installation 1994 Isuzu Trooper
looked, removed bumper but i can not locate the harness to attach to my trailer, which by the way a 4 flat. i have a 1994 isuzu trooper | According to Tow Ready, the connection point is located underneath your 1994 Isuzu Trooper on the driver...
Recommended Trailer Hitch Receiver For 2002 Isuzu Trooper To Install Yourself
Hi, I was wondering if i had to get this welded on. I have a 2002 izuzu trooper and i want to tow a jet ski for now. Possibly 2 at a time. Is this an easy personal install or do i have to take it to a welder/body shop to get it installed? Your...
Bearing Buddies for a Bearing with 1.625 Inner Diameter on a Motorcycle Trailer
Im restoring a 3 rail motorcycle trailer and the last step is repacking the bearings. Id like to get some bearing buddies or sealed type of applicator so I dont have to mess with repacking the bearings, but Im having problems finding something...
Troubleshooting Trailer Connector Not Functioning Properly
My trailer connector is not working properly. Harness is properly plugged in and properly wired. Sometimes it works well, but most of the time, it doesnt. Either the left or the right turn fail to light. It happens with both connectors, the...
Brake Controller Recommendation for 1998 Isuzu Trooper Towing Camper Trailer
I have a 1998 Isuzu Trooper and will be towing a RV trailer with 2 axles weighing 3,200 pounds dry. Which brake controllers would you recommend? | The brake controller I recommend for you is the Tekonsha Prodigy P2 Trailer Brake Controller #...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Distance Between Mounting Holes of ARB Recovery Point ARB23YR
What is the distance between the mounting holes? | Hey Robert, I checked with ARB and the distance between the mounting holes of the ARB Recovery Point for Toyota Land Cruiser # ARB23YR that you referenced is 2-1/8 inches. |
Filter Your Search
Contact and Help