Where Does a Trailer Wiring Harness Install on a 2001 Isuzu Tropper
Updated 02/09/2016 | Published 02/07/2016
Question:
Do I have to remove the wheel well or tail light to find the plug in?
asked by: Tim
Expert Reply:
Trailer wiring harness # C55339 installs in a factory wiring harness located on the driver's side of the back of your 2001 Isuzu Trooper. The factory harness should be attached to a grommet between the rear wheel well and the bumper on the exterior of the vehicle. It appears that it also could be near or above an exhaust pipe.
Since the vehicle is over 15 years old it is possible that the location is covered with road grime and/or is otherwise difficult to see. It may be easier to find if the vehicle was jacked up and the tire removed but it isn't required.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Wiring Solution for 1994 Isuzu Trooper
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: What are the Differences in the AM20334 and the AM20304
- Q&A: Avaialbility Of Trailer Hitch For 2000 Toyota Granvia/Grand Hiace
- Q&A: Working Running Lights, But No Turn Signals or Brake Lights On Trailer
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Q&A: How To Install New 4-Way on Trailer with Brown/Green and Brown/Yellow Wires