!Outback Wagon  x   >   !Salem FSX Travel Trailer  x   >   !Freedom  x   >   Gorilla-Lift  x   >  

My trailer gate is split in half horizontally. Would you put the attaching wire on the end portion or the portion of the gate that is closest to the trailer? | When installing the Gorilla-Lift Utility Trailer Tailgate Lift Assist # GL1 you...

The tension on one side of my gorilla lift is a lot weaker than the other side. Can I repair it | If you determine the spring needs to be replaced on your Gorilla Lift # GL1, you can use the replacement spring # GSCC-400. There is a bolt...

my side rails on my trailer slope downward on the last 3 feet of the trailer. Do I need to square up the end side rails on my trailer or will the gorilla lift work by being about 3 feet from the back of the trailer? | In order for the Gorilla-Lift...

We have a landscape truck with a split gate. Would the gorilla lift work on it? | The Gorilla-Lift Utility Trailer Tailgate Lift products like Item # GL1 are great but unfortunately are designed to work with utility trailers with square tube,...

Will the gorilla lift work on a split ramp trailer gate? | The Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable - 300 lbs # GL1 will work on a split ramp trailer gate. You will install it in the exact same way, you will just split...

Considering purchasing the GORILLA-LIFT package for my utility trailer. I want to have extra lock nuts on hand. What is the size and thread of the Tailgate Attachment Bolt? I can find the information anywhere. Thanks! | The gate attachment...

Does this also hold the tailgate in position during transport? | Typically, a tail gate on a trailer will have a pin that holds the tail gate in place when it is raised for transporting. I would not rely on the Gorilla-Lift Utility Trailer Tailgate...

What size of angle iron on the side rails of the trailer and how high the trailer side rails. How long of tail gate will this work on. Will this work on a 6X12 trailer? | If the side rails of your trailer are between 12 and 24 inches above the...

I currently have one Gorilla Lift on my trailer. It was installed about 3 years ago. Can I add a second lift on the other rail? Will there be a difference of old vs. new for lifting, and spring tension? | Since you've already set the first Gorilla-Lift...

I was looking at the Gorilla Lift for lifting trailer tailgates, while reading reviews It seams that some have had the cables fray and snap. Can you tell me what diameter steel cable is used and is the cable plastic coated or exposed steel?...

I have a large goose neck utility trailer with a large and very heavy gate that is 7foot wide X 5foot tall with lots of thick angle iron and square iron. The gate already has two coil springs attached similar to your RR16933 springs but is...

Gorilla lift is this for one side ? or both sides? | The Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable # GL1 comes with 2 pieces, one for each side of your trailer to pull the gate up evenly. Both pieces combine for a 300lb capacity. |

My trailer has 26inch side height. Can I make this unit work? | I spoke with Rack'Em and they said that the Double Barrel # RA-27C could be modified to work on a trailer with 26 inch side rails. The mounting location of the Double Barrel would...

How are the closed tubes attached to the trailer rails. I do not see any bolts exposed? Are there carriage bolts or what? | Each assembly that goes on one side of the trailer is actually two pieces, which gives you easy access to the mounting...

I have a 2015 trailer it is a 7ft by12 and it has a folding gate can I use the gorilla lift for this gate. Its 4 ft long gate that folds in half | The Gorilla-Lift Tailgate Lift Assist # GL1 is designed for trailers with side rail height from...

I have a car hauller trailor and the ramp/ tail gate is getting too heavy to lift can you lead me in a direction of a spring setup I am pretty hand and can do it but I cant find it on your web site/ | I don't know how wide your rear door is...

can I put these on a trailer with a dove tail trailer | The Gorilla-Lift Utility Trailer Lift Assist you'd looked at (as are all the ones we offer) require that top of the trailer sides be between 12-14 inches above the trailer floor and the...

Is it necessary to remove inner spring? Large springs do the job? | With the Gorilla Lift Ramp Spring Assist # GL1 there are two sets of springs and you can disconnect the inner spring if you want to lower the spring tension and the outer spring...

Does anyone manufacture a tailgate LIFT assist? | We do carry tailgate lift assists for both trucks and for trailers. We have the Hopkins EasyLift Truck Bed Tailgate Lift Assist # 74211 that will fit most trucks. If you can confirm your year,...

My trailer is made with 2inch round tubing for the rails. Will this work? Thanks | The Gorilla-Lift Utility Trailer Tailgate Lift Assist # GL1 that you referenced can be applied to an open utility trailer with round-tube side walls. I spoke...

On the Gorilla Lift, can I mount snap hooks on both cables to remove the tailgate? I use my trailer to carry long loads, and with an overhang I must remove the tailgate at times. | Technically, yes, you could install the Gorilla Lift # GL1...

Does this come as a cable or a set of cables to replace?? | The Replacement Cable with Quick Link for Gorilla Lift Utility Trailer Tailgate Lift part # GLC1-Q1 comes with 1 cable and quick link for the Gorilla-Lift Utility Trailer Tailgate Lift...

Will this work with the tube cut to fit a 5’ to 51/2’ top rail on a 100 lb. tailgate? | The springs inside the Gorilla-Lift Utility Trailer Tailgate Lift Assist # GL1 are nearly as long as the outer tubes so you would not be able to trim them...

Which is better for a very heavy trailer split tailgate? Gorilla Lift or RackEm Double Barrel Utility Trailer Tailgate? Understand I’d have to buy two of the Double Barrel but are they more better suited for my tailgates? | The only real benefit...