How To Replace Spring In Gorilla-Lift Tailgate Assist
Updated 05/15/2017 | Published 05/12/2017
Products Featured in This Question
Question:
The tension on one side of my gorilla lift is a lot weaker than the other side. Can I repair it
asked by: David
Expert Reply:
If you determine the spring needs to be replaced on your Gorilla Lift # GL1, you can use the replacement spring # GSCC-400.
There is a bolt and nut on the end of the lift that holds the spring in place. When the lift is not under tension you will need to remove the nut an bolt so you can remove the old spring. The rollers on the other end of the lift will also need to be removed so you can safely remove the spring for replacement.
Product Page this Question was Asked From
Replacement Spring and Cable Kit for Gorilla Lift Utility Trailer Tailgate Lift Assist - Qty 1
- Accessories and Parts
- Lift Supports
- Tailgate Assist Parts
- Cables
- Gorilla-Lift
more information >
Continue Researching
- Q&A: Is Drilling Required For Installation Of Roadmaster Front Anti-Sway Bar on 2026 Jayco Melbourne 24L
- Article: Trailer Wiring Diagrams
- Q&A: Replacement for Reliable ACT-7.5K Brake Actuator on Mastercraft Trailer
- Q&A: What Replacement Spring do I Need to Replace My Orange Coded Spring for Enclosed Trailer Door?
- Q&A: Replacement Hub for DICO 45264
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Replacement Return Spring for Bulldog Square Jacks
- Q&A: How to Bypass the Factory Brake Controller w/a Bad Module on a 2014 Chevy Silverado 2500
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: How to Install E-Track in 3 Easy Steps
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices