Result: light switch

Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…

Hello Jeff, Great question! The Bigfoot Hydraulic Jack - Single Pump - Manual Override - 12K #BF84FR does come with a single-point control box included. The control box has two buttons along with a key switch to turn the system on and off. It also…

Jake, have you checked your wiring or any of the fuses? A blown fuse or damaged wiring is where I'd start looking first. If your screen is still having issues after checking your fuses and wiring, then you're going to need to replace the…

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 has 4 35-amp fuses located on the controller. Attched is a complete wiring diagram for you to check out.

For your application you need the Pre-Greased Easy Grease Trailer Hub and Drum Assembly #AKHD-655-35-EZ-K. This matches all of the specs you mentioned and while it's only rated for 3.5K axles, it will still work for your Lippert 4.4K axle since…

Hello L; to flat tow your 2026 Chevy Trax you will need a tow bar, base plate kit, safety cables, wiring, and a supplemental brake system. I recommend the following: -Roadmaster Direct-Connect Base Plate Kit #RM25EQ -Roadmaster Falcon 3HD Tow Bar…

I have good news, our trailer jack that has a 2 inch outer diameter part #DL74MR would fit and work well. While it has a 1,000 lb weight capacity that does not mean 1,000 lb total trailer weight capacity. That capacity is the tongue weight capacity…

Hi David; the TowSmart ProClass 7-Blade Trailer Connector w/ Wire Tester #TS86RR uses screw terminals inside the connector to secure the wires. It has a gasket where the wires enter the connector to help keep out water and debris.

I was able to determine that your Lippert axles are 3,500 lb capacity axles so the Roadmaster Comfort Ride Shock kit you'd want would be the part #RM-2450.

Hi Richard, I'm pretty sure they are the same thing, and the issue is mostly rounding (bear with me a second). The wheel studs that say they have a .54 generally have a .545. Technically, that should round up to .55, but not all do for one reason…

The closest option we'll have to your Atwood 33535E LP/CO2 Detector is going to be the RV Propane Gas and Carbon Monoxide Detector #RS54FR that you were already looking at. It comes with two mounting plates to try and eat up some of your old…

Hey Robert, this is a really great question. In short, you can use the Redarc In-Vehicle BCDC Trailer Battery Charger part #RED36TR to charge your battery on your trailer. There are some extra parts you will want to pick up as well. 60-Amp MIDI Fuse…