Search: stabilizer jacks > RV Leveling Blocks >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Roger, I was able to pull up the dimensions of the battery you have now and found that the Bright Way replacement battery part #3801250 is exact same dimensions and is also a 5 amp hour battery so it would work great for you.
view full answer...Hey Allen, thanks for reaching out. For bolting on the etrailer Scissor Stabilizer Jacks #e36VV the recommended hardware is self-tapping 3/8" x 1" screws. If you use that, you won't need any bolts or washers or anything. You'll want…
view full answer...Hey MLu! As long as you're within the spacing requirements the Super Grip Chock Wheel Stabilizers #UF21-001091 will work with the 17" wheels/tires on your Brinkley. These are designed for 1" - 10-1/2" wheel spacing. If you're…
view full answer...We don't have a video of the #GL1 installed on a bi-fold trailer ramp but I did attach a picture we got from a customer who installed it on a bi-fold ramp setup for you to check out as well.
view full answer...The Gorilla Lift part #GL1 that you referenced could be used on a bi-fold style trailer ramp, but you should note that it would not help at all for extending the second folded portion of the ramp. It would with the first portion of the ramp though.
view full answer...Hey Llyod, the etrailer scissor jack part #e29VV that you referenced weighs 8 lbs. Are you close to the GVWR of your trailer?
view full answer...Hi David; the Timbren Rear Suspension Enhancement System #TDR1500DS is not available with a lower capacity. All of the Timbren SES bump stops come with a high capacity like these. If 1,500 lbs is enough the SumoSprings Solo Custom Helper Springs…
view full answer...Assuming that when you tested the resistance of the brakes you were testing the two wires on each magnet and getting 2.0 and 2.8 ohms the magnets on your trailer are not working correctly and will need to be replaced. For 7" brakes you should…
view full answer...On a trailer tire labeled ST205/75D15 C, the ST stands for Special Trailer which means it is designed for use on boat and utility trailers. The 205 is the section width of the tire in millimeters. The 75 is the aspect ratio (or section height). It…
view full answer...The Electric Trailer Brake Kit part #AKEBRK-35-SA has a self adjusting mechanism which means that you do not need to adjust the brakes for even pad wear after the initial setup. The Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-468-469 also…
view full answer...No you're right on track, a tongue jack like the Stromberg Carlson Electric A-Frame Tongue Jack #JET-2500 that you mention is not designed to support the entire weight of your trailer, only a portion of the weight. When it comes to choosing an…
view full answer...Hello Terry. The white wire is generally the ground, and this should be true for the lights and the trailer harness. You can connect the white wires together and run them all to the same ground, or you can ground each wire individually. It really…
view full answer...Filters
- 30 results
Vehicle Fit
Filters
