Result: Ramp Door Spring

Hey Eddie, the Curt hitch part #C22RJ and the Trailermate part #TMT29FR are both very similar in design and capacity. I really like the Curt hitches and recommend them whenever available but Trailer Mate isn't bad either. If you are wanting the…

Hubs will heat up when driving, but if it feels like they are getting too hot, then you will want to look at a few things on your hub. My guess is that the spindle nut is too tight and the added stress on the bearings is overheating the bearings and…

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

Hey Don. What kind of trailer do you have? We have two types of ramp door springs so I am going to need a bit more information from you. The Replacement Spring Assembly for Buyers Products EZ Gate Tailgate Assist for Open Landscape Trailers item…

For your cargo trailer with a 94" wide door that weighs about 140lbs you'll need to go with the Conventional Ramp Door Spring #362SA8207. This is designed for doors your size, and has a 150lb capacity which will be perfect for your door…

The Fulton plastic trailer fenders #PF11X35W-2 are 13 inches tall so that would be 3 inches shorter than your 16 inch tall fenders. The only issue though is that you have to have enough room above the tires for the travel of the suspension when under…

The dimensions you have are nearly identical to the CE Smith #CE19504-2 you looked at. However, these are designed for 14" wheels. For 15" wheels you would need the Fulton #F008585-2. These are slightly longer and taller at 10-1/4"…

I was able to go out to the warehouse and measure the mounting brackets holes for the PF11X35W and found that it was 5-5/16 inches or 5.3125 inches. If these aren't an exact match, new holes can usually be drilled into the brackets to make them…

As long as your transmission is placed in neutral you will be able to flat tow your 2023 Subaru Crosstrek. To flat tow your Crosstrek you'll need the following parts: Baseplate: Roadmaster Direct-Connect Base Plate Kit #RM-52927-5. Tow Bar:…

The Dexter "8-248" is a hub assembly for 3,500 lb axles that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in both 5 on 4-1/2" and 5 on 4-3/4" bolt patterns therefore you would need to…

I'd go with a double spring personally, Scott. These are typically going to be used on more heavy duty applications like your enclosed trailer with a pretty heavy door. In order to get a proper replacement though, you'd need measure the width…

On a 2007 Ford F-150, you should not need to remove any panels. It should be right by the center section of the dash, by the radio. Go back towards the firewall, and you should find it to the right of the gas pedal arm, but closer to the driver than…