Dimension of Mounting Hole on Redline Trailer Fender # PF11X35W

Published 07/06/2016

Products Featured in This Question

Plastic, Single-Axle Trailer Fender w/ Top and Side Steps - White - 13" to 15"

(59)

$163.19

Galvanized Steel, U-Shaped, Bolt-On Bracket for Plastic, Single-Axle Trailer Fender PF11X35W

(11)

$22.80

Galvanized Steel, U-Shaped, Bolt-On Brackets for Plastic, Single-Axle Fender PF11X35W (Pair)

(39)

$45.17

Question:

how far apart are the openings for the mounting brackets on PF11x35w......I know it doesnt give that information, but dont you have one you could measure????? think I need it to be 5.639

asked by: Ann S

Expert Reply:

I was able to go out to the warehouse and measure the mounting brackets holes for the PF11X35W and found that it was 5-5/16 inches or 5.3125 inches.

If these aren't an exact match, new holes can usually be drilled into the brackets to make them compatible. The recommended bracket for this fender is the # PF1135-BKT, this bracket works well for mounting fenders to a boat or other open sided trailer. The brackets use u-bolts to attach to the trailer frame and then the fenders mount to the brackets as shown in the attached image. The brackets are sold in a quantity of 1 # PF1135-BKT or a quantity of 2 # PF1135-BKT-2. For each fender you will need a set of 2 to mount properly.

I have linked all the above mentioned products to this page for your purchasing convenience.

expert reply by: Jackie C