Search: 7 way tester   >   !Car Tie Down Straps   >   Portable Grills and Fire Pits   >  

Hello Dan, I can definitely help with this. It is completely normal for the Curt TriFlex brake Controller #C24VV to show the current gain setting when the brakes are applied, or when the manual override is pressed. It sounds like you have the gain…

The best replacement option for your 36.5" wide x 16" tall cutout hole is going to be the Furrion Electric RV Fireplace with Crystals #FF40SC15ABL. This unit would have to be 'wall-mounted', which means that only the…

Normally this is corrosion or dirt on the pins of the trailer connectors that only requires some sanding to get rid of and fix. If you already checked for that it could also be a bent pin on the connectors as well. The "no connection" light…

In order to install a brake controller on your 2007 Ford Expedition you will want to use the Adapter 4-Pole to 7-Pole and 4-Pole part #37185 as this will give you both 4 and 7 way connection points on the rear of your vehicle. The rest of the wires…

Yes, you can use the factory trailer connector on your 2015 Nissan Titan to power the third brake light on your Leer camper shell. That said, they don't make a plug and play harness for this so you will need to do some wiring but no splicing into…

The Durabilt Ratchet Chain Binder #DU32MR will close up 8" from 28-1/2" overall length to 20-1/2" overall length. It is designed to fit chains with 5/16" to 3/8" thick links.

Although there are standard bearing and seal combinations, sometimes (especially on older trailers) the "correct" seal won't fit, as you have found out. The closest seal that we have to the 1.654 Inner Diameter (ID) that you measured is…

I called Lippert and they informed me of the grease seal dimensions for your 3,500 lb axle. The correct replacement grease seal for you is part #168255TB.

It sounds like you have the older hub 22834 that is no longer in production that takes the outer bearing of part #1779 and inner bearing of part #2788. I was not able to find any other bearings that measure .093" inner diameter besides 1779 or…

When the battery dies on the Galeo Pro GPS Tracking Device #GA94FR you have to replace the sensor as they do not offer a replacement battery. The battery is hardwired into the unit and not something that can be replaced.

For a 12,000 lb. electric car trailer winch like the Bulldog Winch Trailer Winch part #BDW10040, I recommend a standard 12 volt lead acid battery rated up to at least 650 cold cranking amps (CCA). As long as the battery is rated up to 650 CCA then…

It sounds like you are wanting to install a brake controller and wiring for your trailer on your 2001 Explorer. The wires you mentioned will probably not be the wires for the brakes you asked about. If you do not have a factory trailer connector on…