Result:

Articles

Trailer Hitch for 2021 Polestar 2

Hello and good morning, Ive been eyeing this trailer hitch for a good few months now and Im getting ready to pull the trigger on it. Im just wondering if you recommend any other accessories for pulling something with my Polestar star 2, launch...

What Front and Rear Air Bags do I Need for My 1981 Airstream Excella 28 on a P30 Chassis?

Hello I have a 1981 airstream excella 28 motorhome and I need to replace the front and rear airbags. Do you know the correct replacements? Thanks | Hello Michael, Based on my research, your 1981 Airstream Excella 28 motorhome was built on the...

Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire

I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...

Troubleshooting Trailer Wiring When Connecting a 4 Flat Vehicle Side to 4 Flat-5 Wire Trailer

I have a 2001 Isuzu Rodeo and was recently trying to connect the connector wires to my trailer. My Rodeo is setup to use a 4 flat female end that runs to 4 wires Ground, Tail, L Turn, R Turn to a converter that connects the 4 wires of the end...

Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel

I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...

Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103

do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...

Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer

Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...

Can a 3-Wire to 2-Wire Trailer Wiring Harness Converter be Bypassed

can i by-pass a 3 to 2 wire taillight converter in any way | The only way to bypass a 3-wire to 2-wire trailer wiring harness converter (assuming your vehicle has a 3-wire or separate tail light system) would be to convert your trailer to a...

Availability of Trailer Hitch for 2022 Polestar 2

Hello, I do not see on your website, but checking to see if you have a hitch for 2022 Polestar 2. I know that both Stealth Hitch and Ecohitch have a model for this vehicle. Thanks | We do have a hitch for the 2022 Polestar 2. The Stealth...

Where is Connector Found on 2001 Isuzu Rodeo for Installing Hopkins Trailer Wiring Kit HM43215

I cannot see the plug you guys talk about in the jack compartment, however there is a similar plug on the bottom beside the spare tire is that the correct plug, and do I have to do any other connections? | The plug you have found is the correct...

Recommended Hitch for a 2022 Polestar 2

Looking for hitch for 2022 Polestar Model 2. I know that both stealth hutch and ecohitch make them for this vehicle, but do not see them in your site. So you carry either? Thanks. Mike | Yes, we do! I checked with both EcoHitch and Stealth...

4-Way Trailer Wiring Recommendation for 2002 Isuzu Rodeo

HI first Id like to thank you for you time to answer my question. Ok I have a 2002 Isuzu Rodeo and I want to install a 4way trailer conception. But I only see a connecter with 2 wires one hot and on ground I believe they are the running lights...

Trailer hitch for a 2004 Isuzu Rodeo with 3.5 Liter Engine

my is 2004 rodeo 3.5 liters wish i will use | The only trailer hitch that will fit the 2004 Isuzu Rodeo with 3.5 liter motor is Curt hitch # C13235. But in order for this hitch to fit your Rodeo must have the rear door mounted spare tire. It...

Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103

I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....

Trailer Hitch for a 2012 Mercedes R350 BlueTec

Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...

Trailer Hitch for a 2011 Mazda 2 for a Bike Carrier

I want to buy a hitch for my Mazda 2, a 2011. I have a bike carrier that works with with class2. Will these class 1 hitches work? Or do they have that silly stop to prevent class 2? | Trailer hitch # C11073 does not have the stop in the shank...

Removal of Fascia on Mercedes 2008 R350 When Installing a Curt Trailer Hitch, Part # C13103

Once I get the facia off, I can install the hitch. Any tips? Ive removed the 4 bolts under the rear bumper. How do I get the rest of the facia off? CURT 13103 model hitch. | I spoke with my contact at Curt and he informed me that the underbody...

Availability of Hitch for 2006 Mercedes R500

Does this fit a 2006 Mercedes R500? | We offer two different Class III hitches that are a fit for your 2006 M/B R500. Both the Curt # C13103 and the Draw-Tite # 75470 offer a 3500 lb towing/ 350 lb tongue weight capacity, but the warranty requirements...