How to Pick Out Replacement Brake Calipers for a Boat Trailer
I have a 1994-1995 Ranger bass boat with a matching trailer. I was thinking about replacing the surge brake calipers. Is this something you would carry and what information would you need for matching the part? | To replace the calipers on...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Tow Bar for 1981 Volkswagen Rabbit Pickup
What tow bar will hook up to a Volkswagen rabbit truck bumper, I need one that is 31 inches | Hi Andrew; are you saying you need the arms to be 31" apart? The Curt Adjustable Tow Bar # C19745 you were looking at has an adjustable arm width from...
Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...
Is Larger 5.70-8 Trailer Tire a Better Option to Replace 4.80-8
Hello. I recently bought a small trailer to pull with my motorcycle. It currently has 4.80 x 8 tires. Logic tells me the 5.70 x 8 size will allow slower tire speed and less reaction to road irregularities. My question is about rolling resistance....
Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...
Troubleshooting Jayco Popup Camper Brakes and Tail Light Turn Signals
I recently bought a 2000 Jayco Qwest 10x. Seller could not find the harness adapter, so I wasnt able to check the electrical, but everything else was beautiful so I trusted it was good. Brought it home, purchased the adapter, and have had...
Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer
Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...
Does the Kuat Pivot Swing Away Hitch Extender Need an Anti-Rattle Device
This is going to be perfect! I have a 2” hitch, and a 2” cargo carrier. I want to swing away for back door of van to open. I also want the option to add a bike rack to the cargo carrier and swing away. | I recommend the Kuat Pivot Swing Away...
Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....
Problems With Trailer Light Functions Using Curt Wiring Harness C55355 on 2001 Pontiac Montana
my boat trailer has been towed by three different vehicles with no problems. unfortunately cant get wiring harness 55355 to work properly between my boat trailer and my van2001 pontiac montana with load leveling suspension. have hooked it up...
Trailer Hitch for a 2012 Mercedes R350 BlueTec
Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...
Removal of Fascia on Mercedes 2008 R350 When Installing a Curt Trailer Hitch, Part # C13103
Once I get the facia off, I can install the hitch. Any tips? Ive removed the 4 bolts under the rear bumper. How do I get the rest of the facia off? CURT 13103 model hitch. | I spoke with my contact at Curt and he informed me that the underbody...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Is a 2 inch or 2-5/16 inch Ball a Standard Size for a Hitch Ball
We are picking up this camper from Florida and need to know the ball size of this camper. Friends are putting on the class 3 hitch for our 2000 Pontiac Montana Van, but the seller doesnt know the ball size. These same friends said it should...
Ground Clearance of Curt Hitch Installed on 2008 Mercedes Benz R320 CDI
Is the car just too low for a hitch? | For your 2008 Mercedes Benz R320 CDI we have the Curt hitch part # C13103 as a confirmed fit. This will fit your vehicle will and will not sit too low at all. When we installed this hitch on a similar 2006...
Availability of Hitch for 2006 Mercedes R500
Does this fit a 2006 Mercedes R500? | We offer two different Class III hitches that are a fit for your 2006 M/B R500. Both the Curt # C13103 and the Draw-Tite # 75470 offer a 3500 lb towing/ 350 lb tongue weight capacity, but the warranty requirements...
Will the Thule Pulse XL Roof Cargo Box Fit on the Factory Crossbars on a 2011 Mercedes R350
Hi, I am planning to purchase the Mercedes Benz Basic Roof Rackinch for my 2011 R350. I would like a roof cargo carrier that will work with the Mercedes Benz rack. Will this box fit on the MB Basic Roof Rack?inch The MB Roof Rack has a channel...
How to Determine Which Replacement Axle is Needed for 1979 Avion Travel Trailer
I HAVE A 1979 AVION TRAVEL TRALER WITH 4 SEPERATE AXELS. THE SPINDEL IS BENT ON THE RIGHT FRONT AXEL, THEREFOR WEARING MY TIRE DOWN WITHIN 3,000 MILES. DO YOU HAVE ANY IDEA WERE I MIGHT PURCHASE AN AXEL? THANK YOU | In order to determine which...
Can a 4-Bike Platform Bike Rack be Used on a 1-1/4 Inch Trailer Hitch on a 2011 Mercedes R350
I have a 2011 Mercedes R350 with a 1-1/4 inch hitch. the label on the OEM hitch states that the car has a 280 pound tongue weight. Can I use the Yakima holdup 2 rack with 1-1/4 inch hitch and add to it the Yakima holdup +2 2 bike add on? ...
Troubleshooting Rhino-Rack Roof Rack Installation on 2018 Mitsubishi RVR Flush Rails
Ive tried to install the kit of the SX031 legs on my 2018 RVR, but if you look at the pics those legs are not straight on the flush rails so when I have the bars on them then they dont fit anymore... Am I doing something wrong or I got the wrong...
Torque Specifications to Install the Curt Hitch Receiver C13103 on a 2009 Mercedes-Benz R-Class
The torque setting was not in my instructions. What is the correct torque for the # C13103? | The M10 x 1.50 CL 10.9 fasteners will need to be torqued down to 45 lbs-ft and the 7/16" 59 lb-ft for the Curt Trailer Hitch Receiver # C13103. This...
Installing 7-Way Connector and Brake Controller on 2002 Pontiac Montana
Hello I have right now on my 2002 Pontiac Montana a flat 4 way plug.... I have recently aquired a trailer with a 7 way plug with trailer brakes.... I do not have a brake controller as of yet but soon will be..I would like to know what I need...
Filter Your Search
Contact and Help