Does the Draw-Tite Max-Frame Trailer Hitch Interfere W/ Foot Sensors On a 2024 Honda Prologue
Does this block the foot sensors for the power rear liftgate operation? | Jon, our techs have not reported any issues with that feature so the Draw-Tite Max-Frame # DT38KV won't interfere. If by any chance they don't work traditionally, we've...
Is There Frame Drilling Required to Install Draw Tite Hitch # DT38KV
Does this hitch require drilling in the frame? | Hey Miks, there's no frame drilling required to install the Draw Tite hitch part # DT38KV. There is some trimming of the rear fascia but nothing too crazy at all. What are you planning on using...
Is 2024 Honda Prologue Limited to Listed 150 lb Tongue Weight with Draw-Tite Hitch Installed?
Hi - looking at the Drawtite hitch for the Honda Prologue, the tongue weight limit is 350lb. Looking at the honda prologue specifications, it states a tongue weight limit of 150lb. Do you know if the lower limit on the Honda spec is a limit...
Does Draw Tite Hitch that Fits 2024 Honda Prologue Have Better Ground Clearance Than OEM
Is there any information about how this hitch compares to the OEM hitch sold by Honda? Specifically, I’m wondering if there is a difference in heights from the ground between the two and if the rear trim piece sold by Honda would be compatible...
Do All Hitches for 2024 Honda Prologue Require Frame Hole Enlargement
Hello. I Hope you can help me. I’m looking to lease a 2024 Honda prologue and I need to install a trailer hitch to carry my mountain bike. I can drill into frame under lease. I read some of the comments and it appears the tie down holes need...
Will The DT38KV Interfere With Kick Sensor On 2024 Honda Prologue?
I have a 2024 Honda Prologue Elite. I purchased the Draw Tite hitch model DT38KV. I have read the instructions and I do understand I have to trim an under carriage panel. My question is have you guys run into an issue with the tailgate sensor...
Will the Curt Hitch C89RV Block the Liftgate Sensor on a 2024 Honda Prologue?
Hello, I’m looking to install a hitch on my 2024 Honda Prologue. I have the Touring model. I have a question about C89RV. Does it interfere with the kick tailgate open function the vehicle has? Also, can you provide installation instructions?...
Recommended 4-Way Wiring Harness for a 2025 Honda Prologue
I have a 2025 Honda prologue. It does not have a factory wiring harness. I’d like to add a flat 4 wiring harness for the trailer lights. Can you give me the exact part number? I’m looking for from your site. Thank you. | Hey Tracy. The Curt...
Finding Installer for Curt Hitch on 2009 Kia Rondo
A Curt Trailer Hitch Receiver for a Kia rondo 2009 what car brands aré compatible to install the tráiler Hitch | Hey Adrian, I attached a link to an installer locater that you can use to find someone to install the Curt hitch part # C11031 on...
Does Draw Tite Hitch DT38KV Stick Out Past Rear Bumper
After installation, what is the clearance under the hitch? Does it stick out past the bumper at all? Would mostly be using it for a bike rack and an occasional flat trailer for Home Depot runs. Not a deal breaker at all, but does it block...
Parts Needed to Add Brakes to 1992 Coleman Arcadia Pop-Up Camper
I want to add brakes to my 92 Coleman Arcadia pop-up. I am looking for the correct hub/drum and electric brake assemblies. The wheel bolts are 5 on 4 1/2 and the tires are Carlisle USA Trail 20.5x8-10. The current axle includes a square flange...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Trailer Hitch Recommendation for a 2007 Kia Rondo
I am looking for a trailer hitch for a Kia Rondo that was manufactured in Dec, 2006. I dont see one in your listing earlier than 2007. Thank You | That is because you most likely have a model year 2007 Kia Rondo that happened to be built in...
Recommended Trailer Hitch Receiver for 2011 Kia Rondo
I am looking for a trailer hitch for my KIA Rondo 2011. Do you guys have anything for this models Thanks | For a trailer hitch that fits your 2011 Kia Rondo we have the Draw-Tite Trailer Hitch Receiver # 36525. This is a custom fit Class I...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Wiring Harness With Easy Install For 2009 Kia Rondo
I am interested in the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector for a 2009 Kia Rondo. One of the issues I see in the reviews is that the green wire from the drivers side to the passenger side can be too short....
How to Prevent Exhaust Components from Contacting the Trailer Hitch
I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
Aero Bar Rhino Rack Roof Rack that Fits 2009 Volkswagen Rabbit 5 Door Hatch
Hello, I am looking at RR56RR for my 2009 Volkswagen Rabbit 3 door. Your site says it will fit but when I use the part number RV0230B into rhino racks site it states its only for the 5 door car. Which is correct? I really want these for my...
Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit
Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...
Filter Your Search
Contact and Help